Aveek E9 Wireless Microphone User Guide
- June 2, 2024
- Aveek
Table of Contents
Aveek E9 Wireless Microphone
ACCESSORIES
-
Handheld Microphone*2
-
Receiver*1
-
Dual USB Charging Cable*1
-
Anti-slip Ring*2
-
18650 Rechargeable lithium battery* 2
-
Mic Cover*2
-
1/4″ to 1/8″ adapter* 1
SPECIFICATIONS
Frequency Response: 80Hz-15KHz
Operating Range: Up to 30m
Frequency Stability: ±0.005%
SNR: >60dB
Harmonic Distortion :0.5%(1 kHz)
Sensitivity:- 70dB
Pick up : Cardioid
MICROPHONES STRUCTION
Install Rechargeable Battery Steps:
Step 1: Take down the tail tube of mic.
Step 2: Install the battery and tighten the tube of mic.
Microphone charging method: Connect the USB-A wall charger to the charging
cable and then connect the wireless microphone for charging.
RECEIVER INSTRUCTION
- Battery Indicator
- RF Light
- Power Button
- USB Charging Port
Receiver working hours
Connecting 2 microphones at the same time can work for up to 10 hours,
Receiver battery charging method
Use the usb charging cable to connect the receiver inside the type-c interface for charging, it takes 3-4 hours to be full.
RECEIVER LIGHT INSTUCTION
| RF Light (2) | 2 Orange indicators flashing | Wait for pairing |
|---|---|---|
| 2 Orange indicators are always on | 2 mics complete the **pairing, |
When only 1 mic is paired, 1 of indicator still flashes.
Battery Indicator (1 )| Red light on| The receiver is
charging.**
HOW TO USE
-
Turn on the receiver and the orange power indicator flashes.
-
Connect the receiver to audio equipment such as speakers, sing machine, audio amplifiers, PAsystems, mixers, voice amplifiers(Note: Only compatible with 6.35mm or 3.5mm port audio devices).
-
Press and hold the on button for 2 seconds to turn on the microphone, and the microphone display will light up.
-
The receiver and microphone are automatically paired, and the orange indicator of the receiver stops flashing and stays on to start working,
How to select a frequency?
Microphone A is in the CH A frequency (CH01-CH08) and Microphone Bis in the CH
B frequency (CH09-CH16).
Press the “CH+/-” button first, when “CHA” flashes on the microphone display,
press the “CH+/-” button to switch the frequency, and finally press and hold
the “CH+/-” button to select the current frequency, and do the same operation
for the other microphone B.
OPERATING ENVIRONMENTS & NOTES
When using this device, keep it away from water.
Use the device in ventilated environment, keep
it away from fire.
Since it’s a wireless device, please keep it
away from other interfering sources.
Don’t take apart the device.
Please use the standard power supply, high
voltage may damage the device.
Please place the used batteries into the recycle
bin, don’t litter them.
TROUBLE SHOOTING
| Problem | Solution |
|---|---|
| Microphone cannot be turned on | Check that the microphone and receiver are |
fully charged.
The microphone and receiver cannot be paired| Press the “CH+/-” button, and
when “CHA/B” flashes on the microphone display, press and hold down the
“CH+/-” button to automatically pair the microphones.
Warm Tips:
Users can adjust the high and low sound effect on the amplifier or mixer
according to your need, so as to achieve the best effect.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>