Aveek TW-630 Wireless Microphones Instruction Manual
- June 14, 2024
- Aveek
Table of Contents
Aveek TW-630 Wireless Microphones
ACCESSORIES
SPECIFICATIONS
- Frequency Response: 50Hz-15Khz
- Operating Range: Up to 60m
- Frequency Stability: +0.0005 MHz
- SNR: 96dB
- Sound Distortion: <0.5%
- Mic Input Sensitivity: -51dBV
- RF Sensitivity:- 95dBm
- Operating Temperature: – 0 C to +55 C
MICROPHONES CONSTRUCTION
Install 2*AA batteries before using the wireless microphone and installing instruction is as follows:
- Take down the tail tube of the mic.
- Install the batteries and tighten the tail tube of the mic.
Note: The positive and negative polarity of the battery cannot be reversed.
Important: 2 AA batteries not included
RECEIVER INSTRUCTION
- Battery Compartment
- Signal Antenna
- RF Light
- USB Charging Port
- Battery Indicator
- Power Button
Receiver working hours Connecting 2 microphones at the same time can work for
up to 6 hours.
Receiver battery charging method Use the us charging cable to connect the
receiver inside the type-c interface for charging, it takes 5 hours to be
full.
LIGHT INSTRUCTION
HOW TO USE
- Put the 18650 battery into the receiver battery compartment, turn on the receiver and the green power indicator lights up.
- Connect the receiver to an audio device such as a speaker, Singing Machine, Audio Amplifier, PA system, Mixer, or Voice Amplifier(Note: Only compatible with 6.35mm or 1/4 inch audio devices).
- Open the microphone battery cover and install 2 * AA batteries in the indicated positive and negative directions ( note : the positive and negative electrodes of the battery cannot be reversed).
- Long press the microphone on/off button to turn on the microphone, and the microphone display screen will light up (if the red indicator light illuminates, it indicates low battery power, and the battery should be replaced promptly).
- The receiver and microphone are automatically paired and the receiver RF blue indicator lights up to start working.
OPERATING ENVIRONMENTS & NOTES
- When using this device, keep it away from water.
- Use the device in a ventilated environment, and keep it away from fire.
- Since it’s a wireless device, please keep it away from other interfering sources.
- Don’t take apart the device.
- Please use the standard power supply, high voltage may damage the device.
- Please place the used batteries into the recycle bin, don’t litter them.
TROUBLESHOOTING
Problem/Solution
A microphone cannot be turned on
- Check if batteries are installed reversely;
- Change to new batteries.
The microphone screen shows the red light
- The microphone is in a low-power state, please replace the battery on time.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>