DORMAN H621333 Rear Passenger Side Brake Hydraulic Hose Instruction Manual
- June 1, 2024
- DORMAN
Table of Contents
DORMAN H621333 Rear Passenger Side Brake Hydraulic Hose
Product Information
Specifications:
- Product Name: Brake Hose
- Material: Steel
- Includes: Fittings for end connection
- Compatibility: Refer to the appropriate shop manual for specific vehicle fitment
Product Usage Instructions
- Refer to the appropriate shop manual for your vehicle to obtain specific service procedures for the brake hose installation.
- If you lack the skill or experience, it is recommended to seek the services of a qualified technician.
- Ensure to follow all cautions and warnings included in the shop manual.
- If replacing a steel brake line, ensure to obtain the correct length of the steel brake line and make appropriate bends using a line bending tool.
- If the steel brake line already has flared fittings, you can discard the fitting provided with the hose.
- If fabricating the steel line, use bulk tubing and a double flare tool. The fitting for connection to the hose is included with the hose.
- Ensure that the end of the hard-line attaching to the vehicle’s system matches the style already on the vehicle (inverted double flare or ISO flare).
- This installation should be performed by an experienced technician.
FAQ
-
Q: Can I install the brake hose myself if I don’t have experience?
A: It is recommended to seek the services of a qualified technician if you lack the skill or experience to install the brake hose. -
Q: Do I need any special tools for the installation?
A: You may need a line bending tool if you are replacing a steel brake line and a double flare tool if fabricating the steel line.
INSTALLATION INSTRUCTIONS
ATTENTION: Refer to the appropriate shop manual for your vehicle to obtain specific service procedures for this part. If you do not have a service manual or lack the skill to install this part, it is recommended that you seek the services of a qualified technician. Pay special attention to all cautions and warnings included in the shop manual. Read and follow all instructions carefully.
- A steel brake line may be permanently attached to the brake hose on some vehicles (figure 1). This replacement hose is designed without a permanent steel line. You must obtain the correct length of the steel brake line and make the appropriate bends (figure 2).
- If the steel brake line being used is already equipped with flared fittings, the fitting provided with this hose can be discarded (figure 3).
- If fabricating the steel line with bulk tubing and a double flare tool, the fitting for the end that will connect to the hose is included with the hose (figure 3).
- The end of the hard-line attaching to the vehicle’s system must match the style already on the vehicle (inverted double flare or ISO flare).
This procedure should be performed by an experienced
technician.
Disclaimer
Even though every attempt to ensure this information is complete and accurate, it is impossible to account for all possible circumstances or situations. Please consult with a qualified auto technician before attempting to perform any work you are not qualified to do. Automobiles can be hazardous to work on; be sure to take all necessary safety precautions. Failure to do so may result in property damage or personal injury. Certain motor vehicle standards and performance requirements may apply to your motor vehicle (such as Federal Motor Vehicle Safety Standards by the National Highway Traffic Safety Administration). Be sure that your work is performed by such standards and that you do not disable any motor vehicle safety features.