DORMAN H621211 Rear Passenger Side Brake Hydraulic Hose Instruction Manual
- June 1, 2024
- DORMAN
Table of Contents
DORMAN H621211 Rear Passenger Side Brake Hydraulic Hose
Specifications
- Product Name: Brake Hose
- Material: Steel brake line with fittings
- Compatibility: Refer to appropriate shop manual for vehicle compatibility
- Installation: Requires bending to conform to original brake\ line
FAQ
Frequently Asked Questions
- Q: Can I install the replacement brake hose myself?
- A: It is recommended to seek the services of a qualified technician if you do not have a service manual or lack the necessary skills for installation.
- Q: Do I need to bend the replacement brake line?
- A: Yes, you must use a line bending tool to bend the replacement brake line to conform to the original configuration on your vehicle.
- Q: What if my steel brake line already has flared fittings?
- A: If your steel brake line already has flared fittings, you can discard the fitting provided with the replacement hose.
NOTE: READ INSTRUCTIONS THOROUGHLY BEFORE INSTALLATION WORK BEGINS
Installation Instructions
BRAKE HOSE INSTALLATION INSTRUCTIONS
ATTENTION: Refer to the appropriate shop manual for your vehicle to obtain specific service procedures for this part. If you do not have a service manual or lack the skill to install this part, it is recommended that you seek the services of a qualified technician. Pay special attention to all cautions and warnings included in the shop manual. Read and follow all instructions carefully.
A steel brake line may be permanently attached to the brake hose on some vehicles (figure 1). This replacement hose is designed without the permanent steel line. You must obtain the correct length of steel brake line and make the appropriate bends (figure 2).
- If the steel brake line being used is already equipped with flared fittings, the fitting provided with this hose can be discarded (figure 3).
- If fabricating the steel line with bulk tubing and a double flare tool, the fitting for the end that will connect to the hose is included with the hose (figure 3).
- The end of the hard line attaching to the vehicle’s system must match the style already on the vehicle (inverted double flare or ISO flare).
This procedure should be performed by an experienced technician.
Disclaimer
Even though every attempt to ensure this information is complete and accurate, it is impossible to account for all possible circumstances or situations. Please consult with a qualified auto technician before attempting to perform any work you are not qualified to do. Automobiles can be hazardous to work on; be sure to take all necessary safety precautions. Failure to do so may result in property damage or personal injury. Certain motor vehicle standards and performance requirements may apply to your motor vehicle (such as Federal Motor Vehicle Safety Standards by the National Highway Traffic Safety Administration). Be sure that your work is performed in accordance with such standards and that you do not disable any motor vehicle safety feature.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>