DURASHOCK MUB1A Modular Universal Mini Rubber Bump Stops Instruction Manual
- June 1, 2024
- DURASHOCK
Table of Contents
MUB1A – Medium Universal Rubber Bump Stop
Installation Manual
Please contact us at info@dura-shock.com immediately if you have any questions about installing MUBS on your vehicle. We are a US company located in Southern California.
MUB1A Modular Universal Mini Rubber Bump Stops
(Do not Copy) MUBS is Patent Pending. This instruction is part of an
installation manual that is under Copyright Protection by Dura SHOCK®
WARNING : Customers require common automotive safety practices during the
installation. We recommend hiring a professional with mechanical knowledge.
Dura Shock is not responsible nor be held liable for incorrect or faulty
installations.
For Vehicles
Rear bump stop for Suburban, Tahoe, Yukon, Avalanche, Escalade, Silverado 2500 / 3500
Installed Vehicle
2019 Chevrolet Suburban XLT
Note : Always put a wheel stop on the front end before installation.
Factory Bump Stop Removal
Grab the bump stop, turn, and pull down the bump stop out of the
socket.
Bump Stop Installation
Twist/Wedge and push the MUB1A into the empty socket.
Combinations
-
MUB1A directly replaces the factory bump stop. MUB1A bump stop rear installation on a Chevy Suburban
-
MUB1A + MUB2
Results: Smooth and fast rebound after hitting speed bump or curb side.
-
Add MUB2 x2 to provide extreme support for under heavy loads and increase ground clearance. Approximately 1”, From 38”->39”.
Use included rubber glue to secure UB2 to UB1
Rubber Block RB275-2-175 and coil spring buffer CSB
Super-BP are also installed on the rear end to achieve the extra 1” ground
clearance
MUB1A
MUB1A – Direct Rear Bump Stop replacement for Suburban, Tahoe, Yukon,
Avalanche, Escalade, Silverado 2500 / 3500
MUB2
MUB2 – Optional add on to MUB1A for added support and ground clearance for
vehicle rear suspension. You can add as many MUB2 as you want to fit your
needs. Please use included rubber glue if you want to permanently attach MUB2
module to MUB1A.
Tip: For occasional heavy load on the rear end, you can jack up the
vehicle to install as many MUB2 to MUB1A so the combination of the MUB series
will lightly connect vehicle frame and the leaf spring/axel.
After releasing the lift, the bump stop will be used as an in between cushion.
This will provide a smoother ride on rough road conditions and fast rebound
after passing through dips or pot holes.
www.dura-shock.com
E-mail: info@dura-shock.com
Tel:562-287-4973
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>