DURASHOCK MUB1B Modular Universal Mini Rubber Bump Stops Instruction Manual
- June 1, 2024
- DURASHOCK
Table of Contents
DURASHOCK MUB1B Modular Universal Mini Rubber Bump Stops
Important Information
Please contact us at info@dura-shock.com immediately if you have any questions about installing MUBS on your vehicle. We are a US company located in Southern California.
(Do not Copy) MUBS is Patent Pending. This instruction is part of an installation manual that is under Copyright Protection by DuraSHOCK®
WARNING : Customers require common automotive safety practices during the installation. We recommend hiring a professional with mechanical knowledge. DuraShock is not responsible nor be held liable for incorrect or faulty installations.
For Vehicles
Jeep Wrangler JK, Chevrolet/GMC Express/Savana 1500/2500/3500/ 4500, Silverado 3500, GMC Sierra 3500
Installed Vehicle
2018 Jeep Wrangler JK
Installation
MUB1B
Steps to remove and install the rear bump stops
- Factory Bump Stop Removal : Grab the bump stop, turn it, and pull it down.
- DuraShock Bump Stop Installation : Twist/wedge and push the MUB1B into the socket.
MUB1C
Steps to remove and install the front bump stops
-
Place the jack on the vehicle’s frame for best support/stability and jack up the vehicle.
Note: Vehicle has long suspension travel, raise until coils are fully decompressed.
-
Remove the old bump stop using pliers or a screwdriver. (Please note that the bump stop may be subject to destroying it in the removing process)
-
The MUB1C may require lubrication such as grease, soapy water, or WD40 to assist with the installation.
Photo below is for reference and shows fitment of MUB1C and MUB2
-
You can install the MUB1C on its own (A), or adding a MUB2 (B), or adding two MUB2 (C)
-
To fully complete the installation, insert the MUB1C and place a small wood block that fits inside the coil.
-
When ready, slowly lower the vehicle. The weight of the vehicle and wood block will allow the MUB1C to get installed. Once installed, jack up the vehicle and remove the wood block.
Combinations
| MUB1B | MUB1B directly replaces the factory bump stop. |
|---|---|
| MUB1B + MUB2 | Add an MUB2 to the MUB1B to provide extra support for off- |
road driving.
MUB1B + MUB2 + MUB2| Add MUB2 x2 to provide extreme support for heavy
loads and rock climbing –extra lift.
Rear installation on a Jeep Wrangler JK
Results: Very smooth and fast rebound after hitting speed bump or curb side.
Customers Support
www.dura-shock.com
E-mail: info@dura-shock.com
Tel: 562-287-4973
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>