PZ CV-W061 Crew Cab Running Boards Instruction Manual

PZ CV-W061 Crew Cab Running Boards

Tools Required

• 13mm Socket
• Ratchet
• Torque Wrench

Notes

• Read this instruction carefully before starting installation.
• Proper tools will improve the quality of installation and reduce the time required.
• If missing parts or any damage is found, please take a picture, and contact us.

Step 1

1. Locate (3) mounting positions on each side.
2. There are 4 mounting positions on each side, we will use the 1st, 2nd, 4th.
3. Clean the sealant and dirt around mounting positions.
4. Remove rubber plugs and clean factory threaded inserts.

Step 2

1. Attach the bracket to the rocker panel and secure it with (2) M8 hex bolts, and (2) M8 flat washers.
2. Repeat to install other brackets, do not fully tighten.

Step 3

1. Remove (6) M8 hex bolts and (6) M8 flat washers behind the step bar.
2. Slide mounting tracks to proper positions.
3. With assistance, lift and attach the step bar to brackets. Secure the step bar on brackets with (6) M8 hex bolts and (6) M8 flat washers.
4. Repeat to install the other side step bar, do not fully tighten.

Step 4

1. Tighten M8 hex bolts on a vehicle with 15 ft. Ibs. torque.
2. Adjust the step bar to level and tighten M8 hex bolts with 15 ft. Ibs. torque.
3. After the step bar is installed, periodic checks to ensure all mounting hardware remains secure and tight.

Part List

Read User Manual Online (PDF format)

Download This Manual (PDF format)

Download this manual  >>