DOWELL 4012-0218 Aluminum Bottom Mount Pull Out Waste Container Installation Guide

DOWELL 4012-0218 Aluminum Bottom Mount Pull Out Waste Container

Product Information

Specifications

• Model: 4012 0218 GREY Pull-Out Wire Basket
• Recommended tools:
  • Drill
  • Measuring tape
  • Screwdriver
  • Pencil

Installation Guide

1. Measure the space where you want to install the wire basket.
2. Mark the drilling points using a pencil based on the measurements provided in the manual.
3. Drill holes using the drill at the marked points.
4. Attach the wire basket securely using screws and a screwdriver.
5. Test the functionality of the wire basket by pulling it in and out to ensure smooth operation.

FAQ (Frequently Asked Questions)

• Q: Can I adjust the height of the wire basket?
  A: The height of the wire basket is fixed and cannot be adjusted.

• Q: Is the wire basket suitable for heavy items?
  A: The wire basket is designed to hold lightweight to medium-weight items. Avoid placing heavy items to prevent damage.

Product parts

Part List

Recommended tools You Will Need-Outils Requis

INSTALLATION INSTRUCTION

1. Align the arrow direction of the paper card with the edge of the cabinet, place the center line of the paper card on that of the cabinet, and use a 2.5-mm drilling bit to drill holes on the baseboard of the cabinet. Al ign the left and right guide rails with the holes shown in the figure, and secure the first step with six ST4x14mm self-tapping screws.
2. As shown in the figure, fix the door panel connector 1 and slide rail with 2pcs M4x8mm screws. Then, fix the baseboard with 4pcs M5x8mm screws to complete the second step.
3. Insert 2pcs of support bars into the bottom tube according to the arrow direction shown in the figure, and then insert 2pcs of U-shaped bars into the tube according to the arrow direction shown in the figure to complete the third step.
4. As shown in the figure, fix door panel connector 2 on the outside of door panel connector 1 with 4pcs M5x8mm screws and 4pcs M5 nuts. Then, the fourth step is completed.
5. As shown in the figure, drill 4 pre-assembly holes with a 2.5mm drilling bit, and fix the door panel fasteners with 4 PCS ST4x14mm screws. (Note that the fixed holes are 4 long holes at this time, and the screws should be in the middle of the long holes.) Reserve for the next step when fine-tuning the cabinet door, and complete the fifth step of installation.
6. According to the figure, assemble 4pcs M6x12mm screws and 4pcs M6 nuts together with the door panel fasteners and door panel conncetor 2. After adjusting the door panel, fix it with 8pcs ST4x14mm screws, and put the trash can into the assembled products to complete the installation.

Read User Manual Online (PDF format)

Download This Manual (PDF format)

Download this manual  >>