DOWELL 4011 270 24 White Plastic Lazy Susan Installation Guide
- June 1, 2024
- DoWell
Table of Contents
DOWELL 4011 270 24 White Plastic Lazy Susan Installation Guide
Plastic Kidney Lazy Susans
Insatalltion Instructions for the
IMPORTANT:
Before you begin, make sure you familiarize yourself with all the parts and
fully read the instructions.
TOOLS NECESSARY
Screw gun or Phillips screwdriver, and tape measure. NOTE: If screw gun has a
clutch, set to lowest setting so as not to over tighten and/or strip screws.
| Top Mounting Support | 1 |
|---|---|
| Pole Assembly | 1 |
| Plastic Shelf | 2 |
| Shelf Hub | 2 |
| Shelf Support | 2 |
| #8 x 5/8 Pan Head Phillips Wood Screw | 4 |
| #8 x 3/4 Flat Head Phillips Wood Screw | 4 |
Recommended tools You Will Need-Outils Requis
-
Drill
-
Measuring tape
-
Screwdriver
-
Pencil
Measure and Mount Supports
Mark layout for lower mounting support by placing a shelf into the cabinet upside down. Center the shelf on the bottom of the cabinet making sure you have proper clearance from cabinet walls and door. Mark the mounting location by tracing inside the hole in the middle of the shelf. Measure the center of bottom mounting location and transfer to the top of the cabinet. Align Top Mounting Support with center detent marks and install with four (4)-#8 x 5/8 Pan Head Phillips Wood Screw. Place one (1) Shelf Support onlower marks and secure with four (4)-#8 x 3/4 Flat Head Phillips Wood Screw to the bottom of the cabinet as shown (align set screw for proper shelf orientation).
Install Hubs
Press one (1) Shelf Hub into the bottom of the Plastic Shelf as shown creating
the Shelf Assembly. Repeat with other shelf
Shelf Assembly
From the top slide one (1) Shelf Assembly, the other Shelf Support and then
the other Shelf Assembly onto the Pole Assembly as shown. Slide bottom of Pole
Assembly into the lower mounting support.
Pole Extension
Holding onto the lower pole twist the upper pole counter clockwise to release. Extend pole upwards until it rests firmly against the Top Mounting Support and tighten by turning the pole clockwise.
Shelf Adjustment
Raise upper Shelf Assembly to desired height and tighten the Locking Set Screw. Raise lower Shelf Assembly and tighten that Locking Set Screw
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>