DOWELL 4012-0115 Bottom Mount Pull Out Waste Container Kit Installation Guide

: June 1, 2024
: DoWell

Table of Contents

DOWELL 4012-0115 Bottom Mount Pull Out Waste Container Kit
Product parts
Installation Instructions
Read User Manual Online (PDF format)
Download This Manual (PDF format)

DOWELL 4012-0115 Bottom Mount Pull Out Waste Container Kit

DOWELL-4012-0115-Bottom-Mount-Pull-Out-Waste-Container-Kit-
product

Specifications

Product Name: Pull out Wire Basket
Model Number: 4012 0115 GREY
Color: Grey
Material: Metal wire, Plastic
Dimensions: 7″ (178mm) x 8-3/8″ (212mm) x 3-15/16″ (100mm)

FAQ

Q: What should I do if I encounter difficulties during installation?
- A: If you face any challenges during installation, please refer to the user manual for detailed instructions or contact our customer support for assistance.
Q: Can the wire basket be easily removed for cleaning?
- A: Yes, the wire basket is designed to be easily removable for cleaning purposes. Simply follow the installation steps in reverse to detach it from the cabinet.

Product parts

DOWELL-4012-0115-Bottom-Mount-Pull-Out-Waste-Container-Kit-
fig-1

Part List

DOWELL-4012-0115-Bottom-Mount-Pull-Out-Waste-Container-Kit-
fig-2

Recommended tools You Will Need-Outils Requis

DOWELL-4012-0115-Bottom-Mount-Pull-Out-Waste-Container-Kit-
fig-3

Installation Instructions

DOWELL-4012-0115-Bottom-Mount-Pull-Out-Waste-Container-Kit-
fig-4

Align the arrow direction of the paper card with the edge of the cabinet, place the center line of the paper card on that of the cabinet, and use a 2. 5-mm drilling bit to drill holes on the baseboard of the cabinet Align the left and right slide rails with the holes shown in the figure, and secure the first step with six ST4x14mm self-tapping screws.
As shown in the figure, fix the door panel connector 1 and slide rail with 2pcs M4x8mm screws. Then, fix the baseboard with 4pcs M5x8mm screws to complete the second step.
Insert 2pcs of support bars into the bottom tube according to the arrow direction shown in the figure, and then insert 2pcs of U-shaped bars into the tube according to the arrow direction shown in the figure to complete the third step.
As shown in the figure, fix door panel connector 2 on the outside of door panel connector 1 with 4pcs M5x8mm screws and 4pcs M5 nuts. Then, the fourth step is completed.
As shown in the figure, drill 4 pre-assembly holes with a 2. 5mm drilling bit, and fix the door panel fasteners with 4 PCS ST4x14mm screws. (Note that the fixed holes are 4 long holes at this time, and the screws should be in the middle of the long holes.) Reserve for the next step when fine-tuning the cabinet door, and complete the fifth step of installation.
According to the figure, assemble 4pos M6x12mm screws and 4pcs M6 nuts together with the door panel fasteners and door panel conncetor 2. After adjusting the door panel, fix it with 8pos ST4x14mm screws, and put the trash can into the assembled products to complete the installation.