TECHPICCO B0CGLB68S3 Mud Flaps Compatible with Honda Pilot 2023-2024 Installation Guide

TECHPICCO B0CGLB68S3 Mud Flaps Compatible with Honda Pilot 2023-2024

Specifications

push pin
OPTIONAL| Self-Tapping Screws, Push Pins, Spring Nuts|

1. Cut 2 slits
2. Insert spring nuts with the flat ends facing out
3. Secure with nuts with the self-tapping screws

OR

1. Drill 2 holes
2. Secure with push pins

Installation Steps

For the FRONT guard:

• Reuse the original screw.
• Utilize self-tapping screws to create a new hole if necessary.

For the REAR guard:

• Reuse the original screw.
• Use a push pin to secure the guard.

For OPTIONAL setup:

• Option to cut slits and use spring nuts and self-tapping screws.
• Alternatively, drill holes and secure them with push pins.

FRONT Installation Diagram Description

• The diagram shows the left front splash guard being fitted onto a car wheel arch with the original screw and additional self-tapping screws. There are optional holes to drill, which can be installed using spring nuts and screw or push pin.

REAR Installation Diagram Description

• The diagram illustrates the rear bumper guard installation, highlighting the placement of the original screw and the push pin for secure fitting.

REPEAT RIGHT SIDE

• The installation process described for the left side should be repeated on the right side of the vehicle.

FAQ

What tools are needed for the installation?

You may need self-tapping screws, a drill (optional), and push pins, depending on the method of installation you choose.

Is it necessary to drill holes?

Drilling holes is optional. If you choose not to drill, you can use the alternative method of cutting slits and using spring nuts or securing with push pins.

Can the original screws be reused?

Yes, the guide specifies that the original screws should be reused for both the front and rear guards.

Are the installation steps the same for both sides of the vehicle?

Yes, the installation steps for the left side should be repeated for the right side of the vehicle.

Installation Instructions

• USE SELF-TAPPING SCREWS TO PIERCE A HOLE
• OPTIONAL HOLES TO DRILL [INSTALL USING SPRING NUTS & SCREW OR PUSH PIN]

OPTIONAL

1. CUT 2 SLITS
2. INSERT SPRING NUTS (WITH THE FLAT FACING OUT)
3. SECURE THE SPRING NUTS WITH SELF-TAPPING SCREWS

1. DRILL 2 HOLES
2. SECURE WITH PUSH PINS

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>