Zhongyi 966-M1116Q 3 IN 1 Foldable Fast Wireless Charger User Manual

June 1, 2024
Zhongyi

3IN1 Foldable Fast Wireless Charger with Touch Night Light

User manual (966-M1116Q)

Notice: To ensure charging 3 devices safely and efficiently, you must use 5V/3A adapter and quick charge cable, if including 15W fast charging phones, you must use 9V/3A or 12V/2A adapter and quick charge cable (if not use the appropriate adapter and quick charge cable, the charger may not Charge phone fast, or may not charge 3 devices simultaneously, or may even damage the charger.)

Product Introduction

The 3-in-1 wireless charger with touch night light, a compact charging house, powered from only one outlet, can charge 3 devices simultaneously. When charge your mobile phone, apple watches, and your Air Pods 2 or AirPods Pro or some other TWS, just put them on, wireless charging will automatically start. Touch control night light,3 level to adjust the brightness of the light. It can be used as mobile phone bracket as well, mobile phone bracket 90 degree free adjustment. All this will make your desk clean and tidy and make your life easier.

Product Appearance
  1. LED indicator light
  2. Type-C interface input
  3. Wireless charge area for Phone
  4. LED night light
  5. Wireless Charge area for iWatch magnetically
  6. Wireless charge area for TWS earphone
  7. Touch area
Operation Steps
  1. Connect the charger to a 9V/2A, 9V/3A adapter through a type-C quick charge cable to switch on the power;
  2. Put your phone on and charge;
  3. Put the apple watch on and suck it up to charge
  4. Put your earphone case on and charge.
  5. Touch control night light,3 level to adjust the brightness of the light.
LED indicator instructions

The white LED light will keep on when the wireless charging is in stand-by mode.
When charging the phone wirelessly, the LED indicator light will be White breath light.
When charging the smart watch wirelessly, the white LED light will keep on.
When charging the TWS earphone case wirelessly, the white LED light will grow GREEN.
Note: If the LED indicator is flashing WHITE, an unknown object is being detected between the wireless charging pad by FOD (Foreign Object Detection).The device will not begin to charge unl object is removed.

Using the touch night light

When the wireless charging is normally powered on, touch the area” ” ,the brightness will be increased by one gear, there are 3 gears brightness, the light will be off on the fourth me touch.

Charging Schematic Diagram
Vertically or horizontally

Charging 3 Apple devices simultaneously
The phone can be charged by wearing a non-metal case

Applicable Devices

1. Smart Phone:
Apple: iPhone 12, 12Pro,12 Pro Max,SE,11,11 Pro,11 Pro Max, Xs, Xs Max, XR,X, 8, 8 Plus;
Samsung: Galaxy S: FE 5G,205G, 20+ 5G, 20 Ultra 5G, 10, 10+, l0e, 9,9+,8, 8+,7,7 edge,6,6 edge,
6 edge+, 6 G9209, 6 Active; Galaxy Note: 20,20 Ultra SG,10, lOe,10+,9,8,7,6,5;
Huawei: P40 Pro,P40 Pro+ ,P30 Pro; Mate:40 RS,40 Pro,40 Pro+ ,30 SG,30 Pro 5G, 30, 30 Pro, 30 RS, 20 Pro, 20RS,
Xiaomi: 10, 10 Pro, 9, 9Pro, Mix 3, Mix 2s;
Including other devices with wireless charging receiver built-in; other some devices need to add a wireless charging receiver.
2. SmartWatch:
Apple: iWatchS2,S3,S4,S5,S6,SE.
3. TWS bluetooth earphone:
AirPods 2, AirPods Pro
Sumsung Galaxy Buds, Buds+;Huawei Freebuds 2,3; and more TWS(with wireless charging case).

Product Specification

Input: 5V/3A,9V/3A,12V/22A
Phone Output: 15W/10W/7.5W/5W
Watch Output: 2.5W (Apple iWatchS2,S3,S4,S5,S6,SE.)
Earphone Output: 5W (TWS Earphone:
Apple AirPods 2, Pro; Sumsung Galaxy Buds, Buds+;
Huawei Freebuds 2,3; and more.)
Input Interface: Type-C port
Transmission Distance(Phone): 8mm
Conversion Rate(Phone): 80%
Product Size:165 X 108 X 113.3mm

Accessories List

Wireless Charger 1, Type-C quick charge cable1, User manual*l

Attention
  1. Please keep the charger away from water or other liquid;
  2. If you need to clean the charger, please make sure it is not switched on the power;
  3. Using Environment temperature remain 0-25°C.

Made in China

FCC Warning

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

NOTE 1: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
– Reorient or relocate the receiving antenna.
– Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help.

NOTE 2: Any changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

RF Exposure Statement
To maintain compliance with FCC’S RF Exposure guidelines, This equipment should be installed and operated with minimum distance of 20cm the radiator your body. This device and its antenna(s) must not be co-located or operation in conjunction with any other antenna or transmitter.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals