Shantou Chenghai Zhongyi Toy 1203B Rechargeable Toy Car Instruction Manual

June 6, 2024
Shantou Chenghai Zhongyi Toy

Shantou Chenghai Zhongyi Toy
1203B Rechargeable Toy Car
Instruction Manual Shantou Chenghai Zhongyi Toy 1203B Rechargeable Toy Car -
Car

Thank you for choosing our remote control toys
To ensure proper use, please read the instructions below and have a good understanding of the products before use.

Electric Control Products

  • Suitable for children over 6 years old.
  • All electronic products should be carefully used to prevent electric shock.

Maintaining

  • This product contains electronic components.

  • Don’t use it in water or damp environment. Wipe the surface with a cloth.
    1.  Set the switch on the OFF position of the car and the remote control. (if switch is available)
    2. Open the battery cover of the remote control
    3. Install the rechargeable battery pack according to the figure 1 below, and install the battery according to the corresponding “+” and ” – ” poles in the battery box.

  • Close the battery box.

Spare part list

Shantou Chenghai Zhongyi Toy 1203B Rechargeable Toy Car -
spearch

Battery installation

  • Remote control battery installation 1. Remove the battery compartment cover
    2. Install two 1.5V AA batteries (not included) in the battery compartment. Make sure to follow the polarity markings (+ and -).
    3. Close the battery compartment cover

Function key analysis

Shantou Chenghai Zhongyi Toy 1203B Rechargeable Toy Car -
funtion

Remote control

  1. Auto-Demo (Long press for three seconds to turn off the sound automatically)
  2. Spray Flame
  3. Forward
  4. Backward
  5. Left
  6. Right
  7. Svatch

Operations of remote control and cars

  1. Turn the switch on the car and remote control to ‘ON” position. (if switch is available)
  2. Then, operate the car 3.When your car starts to lose performance, power, or function it may be the time to replace the battery or charge the battery pack

Charging time: 45mInutes. use duration. 45minutes, remote control distance: 50metersShantou Chenghai Zhongyi Toy 1203B Rechargeable Toy Car -
spearcha

Note:
When the remote control cannot control the remote control car, first remove the battery of the remote control and re-install the battery, then turn off the power of the remote control car, then turn on the power, and then the remote control resets the frequency.

Car operation

  1. Direction (Figure A)
    The left control lever of the remote control can control the vehicle forward and backward, and the right control lever can control the left and right of the vehicle.

  2. Turn left/right (Figure B)
    When the left rocker of the remote control is controlled up and left / right at the same time, the vehicle will turn left / right.

  3. Drift (Figure C)
    When the car moves forward or backward, move the right control lever of the remote control to the left/right, and the car will drift.

  4. Automatic presentation (Figure D)
    Press the button in the upper left corner of the remote control once to demonstrate the automatic stunt of the vehicle.(Can rotate 360°) •Stop When you want to stop the auto demo function, press any button on the remote control.

  5. Spray (Figure E)
    Press the button on the upper right corner of the remote controller and the car will spray.

Note:
(Fill water into the water fillingnozzle. Pay attention not tofill the water too full to avoidoverflow. Screw on the softcap after adding water).

Matters needing attention

  1. This product contains non replaceable batteries. Please do not disassemble or damp the batteries.
  2. 1t is recommended that the battery and the product should be stored separately in a cool and dry place when the product is not used.
  3. When the spray car is not used, the battery plug is disconnected from the power socket of the spray car circuit board to avoid battery damage.
  4. Please do not charge for a long time unattended. Please disconnect the charger after the product is fully charged.
  5. Do not use toys for children under six years old.

FCC statement
This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions:

  1. this device may not cause harmful interference, and
  2. this device must accept any interference received, including interference that may cause undesired operation.

Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

  • Reorient or relocate the receiving antenna.
  • Increase the separation between the equipment and receiver.
  • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
  • Consult the dealer or an experienced radio/TV technician for help.

Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. FCC Radiation Exposure Statement This device complies with FCC RF radiation exposure limits set forth for an uncontrolled environment. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals