LITEHAWK CRUSHER EVO Monster Truck Instruction Manual
- June 1, 2024
- LiteHawk
Table of Contents
- LITEHAWK CRUSHER EVO Monster Truck
- SAFETY PRECAUTIONS
- BATTERY SAFETY INFORMATION
- CARE AND MAINTENANCE
- LiteHawk R/C Car and Truck Terms 101
- LiteHawk CRUSHER EVO – Transmitter Set Up
- Controller Functions
- Battery and Charger
- Installation of battery into the CRUSHER EVO
- Battery Guidelines
- Care and Maintenance
- Guarantee
- Read User Manual Online (PDF format)
- Download This Manual (PDF format)
LITEHAWK CRUSHER EVO Monster Truck
LiteHawk CRUSHER EVO Precautions – The LiteHawk CRUSHER EVO is not intended for children under the age of 14 unless closely supervised by an adult. Improper use may cause serious injury. Please read NIMH Battery section before use. Do not run in rain, snow or if there is lightning and/or thunder. Do not touch ANY moving parts while the model is powered.
WARNING : CHOKING HAZARD – Small parts. Not For Children under 3 years
CAUTION : Do not touch the running model! Adult supervision is required!
CAUTION : Never insert any sharp objects, pins or screws into the model
as this may puncture the internal battery!
SAFETY PRECAUTIONS
- Keep hands, hair and loose clothing away from moving parts when the model is powered ON.
- Turn off controller/charger and CRUSHER EVO when not in use.
- Remove battery from controller/charger when not in use.
- Parental guidance is recommended for use.
- Keep your CRUSHER EVO in your sight so that you can supervise it at all times.
- New AA alkaline batteries are recommended for use in the controller to obtain maximum performance.
- Your charger is tailor made for the NIMH battery used in your LiteHawk CRUSHER EVO. Do not use it to charge any battery other than that in the LiteHawk CRUSHER EVO.
BATTERY SAFETY INFORMATION
- Requires 3 x l.SV AA batteries (not included)
- Batteries are small objects.
- Replacement of batteries must be done by adults.
- Follow the polarity(+/-) diagram.
- Promptly remove dead batteries from the toy.
- Dispose of used batteries properly.
- Remove batteries for prolonged storage.
- DO NOT incinerate used batteries
- DO NOT dispose of batteries in fire, as batteries may explode or leak.
- DO NOT mix old and new batteries or different types of batteries (i.e. alkaline/standard)
- Always replace the whole set of batteries at one time.
- DO NOT short-circuit the supply terminals
CARE AND MAINTENANCE
- Always remove batteries from the controller when it is not being used for a long period of time.
- Unplug battery from toy when not in use.
- Keep the toy away from direct heat or extreme cold.
- Do not expose the toy’s interior to water or moisture. This can damage the electronic assemblies.
Your LiteHawk CRUSHER EVO is equipped with a NIMH battery.
Special NIMH Battery Instructions:
- Never charge battery unattended.
- Charge battery in isolated area. Keep away from flammable materials.
- Do not expose to direct sunlight. There is a risk of the batteries exploding, overheating or igniting.
- Do not disassemble, modify, heat or short circuit the batteries. Do not place them in fires or leave them in hot places.
- Only charge the batteries with the specified battery charger.
- Only use the batteries in the device specified by LiteHawk.
- Batteries must be recycled or disposed of properly.
- Do not leave plugged into model when not in use.
- Do not charge if battery or connector is wet.
Before charging the LiteHawk CRUSHER EVO please read the following!
- DO NOT leave the battery unattended during charging.
- DO NOT leave the battery plugged into the charger any longer than 4 hours maximum. If the charging light does not turn green in this time, the charger or battery could be faulty – unplug immediately!
- DO NOT install another battery without letting the motor cool first! 5-10 minutes is sufficient.
- DO NOT recharge the battery until it is cool to the touch! 10 minutes is sufficient.
- DO NOT charge if the battery or connector are wet.
- Remove battery from model when charging.
Welcome to the World of LiteHawk!
Before we get ready for your first driving adventure, let’s cover the basics
together!
CRUSHER EVO is a scaled down version of a Monster Truck – it will blast across
all types of terrain and thrill with big slides! The chassis is designed with
4-wheel independent suspension, and long travel shocks that soak up bumps.
Punch the throttle and race up to speeds of 45 km/h (28 mph)!
Attempting to use your LiteHawk CRUSHER EVO without completely reading the
manual may cause injury to yourself and people in the vicinity, as well as
damage to the R/C model. Please read the Instruction Manual thoroughly before
using this product.
LiteHawk R/C Car and Truck Terms 101
Transmitter : The hand-held radio unit that sends throttle and steering
inputs to your model. Also known as the radio or controller.
Servo : Small motor unit in your model that operates the steering
mechanism.
ESC : The Electronic Speed Control provides digital proportional throttle
control to the model’s motor based upon your throttle input on the radio.
LiteHawk CRUSHER EVO – Transmitter Set Up
Always use fresh AA batteries in the Pistol Grip Radio Controller (Transmitter).
- Make sure the transmitter is turned off.
- Open the Battery Compartment by sliding off the cover.
- Insert 3 x AA batteries, noting correct polarity.
- Replace battery door securely.
- ALWAYS REMOVE THE BATTERIES FROM THE TRANSMITTER WHEN YOU WILL NOT BE USING YOUR MODEL FOR LONG PERIODS OF TIME.
- Dispose and recycle correctly when there is no longer power in the batteries, they should be disposed of at an approved battery recycling center. DO NOT THROW IN HOUSEHOLD WASTE!
- Never expose the transmitter or batteries to moisture.
LiteHawk CRUSHER EVO – 2.4 Ghz
Your LiteHawk CRUSHER EVO comes with a 2.4 Ghz radio system, which allows you
to play without the fear of ever losing control! Race or play with countless
other drivers. The range of your model is approximately 150ft which, due to
its small size, is in excess of normal vision. The farther the model goes away
from you the smaller it will become and the harder it will be to determine the
model’s direction We suggest you stay at a distance between 20ft-50ft, this
keeps your CRUSHER EVO within a safe operational distance.
Quick Tip : always turn the transmitter on first and off last.
Controller Functions
Battery and Charger
Your LiteHawk CRUSHER EVO comes with a 8.4 Volt NIMH battery, and a USB charger.
Battery
The rechargeable battery provides the power to propel your model at high
speeds. You should expect 7-10 min run time. Extra batteries are available at
www.litehawk.ca
- Once the model starts to slow, drive your model to a safe place, walk over and turn it
- Never dead short a NIMH battery (never touch positive and negative together)!
- You Must FULLY charge the battery before using your new model.
- Do not leave the battery plugged into the model when it is not being used.
- Keep the battery dry at all times.
NIMH Battery and Charger Instructions
Your New LiteHawk comes with a rechargeable NIMH battery. This battery
powers the vehicle.
Please read the following information before using your new LiteHawk.
- When plugging in the USB cable to the power, the USB cable will turn a solid RED.
- When charging, the USB will turn to a blinking GREEN light.
- When finish charging, the GREEN light will be ON all the time.
- Charging time is about 3 hours.
The USB cable comes equipped with short-circuit protection. If the USB short-
circuits while charging, the light will be RED and BLINKING.
The USB cable also comes equipped with overvoltage protection. When the
voltage is higher than sustainable, the Red light will be OFF.
During charging
- It is normal for the battery to get warm during the charging process.
- Do not charge the battery on a surface that is flammable or can be damaged by heat.
- Do not leave the battery and charger unattended while charging.
- Do not store the battery plugged into the charger
Installation of battery into the CRUSHER EVO
Place your CRUSHER EVO on a clean flat surface. Avoid areas where small parts may be lost. The battery is housed in the battery compartment located in the top of the chassis. You will see 2 turn tabs or latches that hold the cover in place.
- Turn the tabs, open the battery compartment door.
- Place your fully charged battery in the battery slot. Connect the battery connector. Don’t force it, it only goes one way!
- Close the battery compartment door and turn the tabs back into place.
How to Start!
Litese steps careful VO is ready to use – however you must follow
- Switch ON the transmitter.
- Plug in the battery in the CRUSHER EVO.
- Turn the CRUSHER EVO power switch ON.
Battery Guidelines
- The battery can be re-charged many times, however over time the battery will lose its ability to take or hold a charge. At this point the battery will need to be properly recycled.
- Do not store or leave batteries in areas with extreme heat or cold. Batteries should be left and stored at room temperature.
- Always have the battery unplugged from the toy or charger when not being used.
- Do not submerge batteries under water. Always wipe off any water with a clean towel or rag.
- It is best to store the battery out of the toy and on a non-flammable surface.
Before you drive
Before every use it’s recommended to check that the steering and drivetrain
are moving freely and nothing is binding. Next ensure that the model and the
transmitter are working correctly. Before you drive your model, range test the
radio system to ensure that it operates properly! Turn on the transmitter and
then the model, check its operating as it should. Walk away from the model
giving steering input with the radio until you reach the maximum distance you
are planning to drive your model. If you lose input control walk back towards
the model. You now know the safe operating distance for your immediate
environment. Do not attempt to operate the model if there is any problem with
the radio system/external interference with your radio signal at your
location.
Let’s hit the road
When heading out to drive your model, it’s important to always use common
sense. Your new Car/Truck is fast and at top speed you are covering over 32ft
per second! For this reason it is best to stand in the middle of the area that
you want to use your car. Doing this will keep the Car/Truck closer to you and
maximize the radio range. Driving in an abusive and or rough style will only
result in damage, broken parts, or poor performance. The ESC system is not
waterproof. Avoid driving through puddles, mud, or snow. If water gets into
the electronics it could damage them.
- Avoid overloading your model. Never run it in areas where its movement will be restricted, e.g.thick grass, weeds, mud etc. as this can over stress the motor and bind the drivetrain.
- Ensure nothing prevents the smooth running of the moving parts.
- Do not run your model in confined spaces. This is an outdoor toy, do not run in your home.
- Never run your model in a public space where it might upset or endanger people or wildlife.
- Immediately discontinue use of your vehicle and transmitter if you see lightning or hear thunder. Never use your vehicle in the rain.
- Do not dismantle or tamper with this R/C vehicle or its transmitter. The manufacturer and distributor will accept no responsibility, expressed or implied, for accidents or injuries caused as a result of disassembly, modification and/or usage against the instructions for this product.
- The transmitter’s range will vary depending on your surroundings and battery strength. Do not operate the model too far away or control could be lost (stay within 20-50 ft)-
- Ensure that all batteries are correctly installed and that the NIMH battery is fully charged and in good condition.
- Do not touch ANY moving parts during operation.
- Don’t run in public roads with traffic!
- If your Car/Truck becomes stuck against something, release the throttle. Do not continue to push the throttle or run the motor. Do not try to push, pull, or tow objects of any weight as this will increase heat in the electronics and cause failures.
After Use Care
- When you have finished using your LiteHawk CRUSHER EVO you should first disconnect the NIMH battery, then switch OFF the transmitter.
- Remove the NIMH battery from the vehicle.
Care and Maintenance
When you are finished running your model for the day, blow it off with
compressed air or use a soft bristled paint brush to dust-off the vehicle.
Always disconnect and remove the battery from the model whenever the model is
stored. Your model is going to require maintenance in order to stay in tip top
running order.
Check for the following:
- Check the wheels and steering for binding.
- Check the tightness of the wheel nuts with the wheel wrench.
- Look for any cracked, bent, or damaged parts
- Check for any loose screws in the chassis structure or suspension
- Inspect the gears for wear, broken teeth.
Storage
- Remove all batteries before storing your vehicle.
- Never store your LiteHawk CRUSHER EVO near open flames, in high temperatures (including near radiators) or in direct sunlight. Ideally, place the model in a warm dry location.
- Care must be taken when handling rechargeable batteries to avoid the possibility of injury and/or damage to property.
LiteHawk Parts & Tech
There’s nothing worse than buying a new toy, having a question, or needing a
replacement part, and then being left out in the cold. No worries! We pride
ourselves on the very best customer service!
We have all the parts you’ll ever need to keep your new LiteHawk in tip top
shape! Like we always say, “accidents happen, even to the best of us”…with
that in mind www.litehawk.ca is available 24 hours a
day, 7 days a week!
We ship your parts Same Day! Except weekends of course – that’s when we are
out playing too!
Guarantee
All LiteHawk products have been tested and designed to perform as claimed out of the box. If you have an issue with a product or part of a product please contact us directly. We cover claims towards manufacturing defects. We know that there is nothing worse than having a question or needing a replacement part and having nowhere to go. LiteHawk is not responsible for covering the costs of replacement parts or repair on products that have been damaged due to product use.
See all of our Litehawk products in action! Everything from videos that show LiteHawks in their natural environments – flying, sailing, power boating….to helpful In-Depth product information too! It’s all just a mouse click away!
Get the inside scoop – by joining LiteHawk INSIDER e-bulletin!
Keep up to speed with our newest product releases we have some great stuff
just around the corner! Ever missed a contest, simply because it happened so
fast? Heck, it was over before you even got to the party! LiteHawk will never,
ever share your email address – it’s private and we respect that.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>