Bernette 502040 Beading And Sequin Foot Owner’s Manual
- June 1, 2024
- bernette
Table of Contents
Bernette 502040 Beading And Sequin Foot
Beading and Sequin Foot
For creative work with beaded or sequin tapes up to a width of 4 mm. The side groove serves as a guide and for couching cords. Article number: 502040 60 20
Instruction
- Set the machine for a 3-thread rolled hem or 3-thread flatlock (left needle for wider beads and, the right needle for smaller beads).
- Beads up to 5/32″ (4 mm) diameter can be used.
- Adjust stitch length to suit beads and pearls.
- Raise the presser foot and snap on “Beading and Sequin foot”.
- Place strands of beads/sequins in the guide (1) and (2) to the end of the foot.
- Lower the foot, and sew a few stitches to fix it.
- Place the fabric under the foot and sew.
- Note: If the strand of beads is sewn onto the fabric edge, cutting can be activated.
- If the strand of beads is sewn on with a flatlock, fold the fabric accordingly and guide about 1.5 mm from the right of the needle, it should penetrate the fabric edge.
- Cutting can be deactivated if needed.”
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>