bernette 502060 14 88 2 Grooves Sewing Machine Piping Foot Instruction Manual
- June 4, 2024
- bernette
Table of Contents
502060 14 88 2 Grooves Sewing Machine Piping Foot
Instruction Manual
Piping Foot
Information
Purpose
- For creating and sewing on piping.
- For working with cords up to 5 mm in diameter.
For your safety
Before using this accessory, please read this instruction manual as well as
the instruction manual of your machine carefully.
Application
Creating piping tape
- Fit the Piping Foot.
- Set the straight stitch with needle position to center.
- Set the optimal thread tension.
- Set the stitch length to 2 3 mm.
- Fold the bias tape lengthwise. Place the cord between the folded tape halves and pin it in place.
- Guide the cord under the right groove on the underside of the presser foot. (Fig. 1)
- Sew the piping tape together close to the cord. If necessary, adjust the needle position by a maximum of 3 steps.
Sewing on the piping
- Fit the Piping Foot.
- Set the straight stitch with needle position to center.
- Set the stitch length to 2 3 mm.
- Place the piping tape on the right side of the first layer of the fabric so that the edges lie on top of each other. (Fig. 2)
- Sew the piping tape in place, guiding the cord in the left groove.
- Place the second fabric layer right side on the right side of the first layer and pin it in place. The piping tape lies between the fabric layers. (Fig. 3)
- Position the sewing project under the presser foot so that the seam that has already been sewn is on top. If necessary, move the needle position to the right by a maximum of 3 steps so that the seam is sewn close to the piping.
- Sew on the piping tape close to the piping, guiding the cord in the left groove. (Fig. 4)
www.bernette.com
5600006.00A.04
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>