HUSSMANN Washington State Regulations GWP Limits Equipment User Guide
- June 1, 2024
- HUSSmAnn
Table of Contents
HUSSMANN Washington State Regulations GWP Limits Equipment
Specifications
- Model: Not specified
- Manufacturer: Not specified
- Compliance: WA Dept. of Ecology Regulations
- Effective Date: January 1, 2025
Product Usage Instructions
Overview
The product is designed to comply with the GWP limits set by the Washington
State Department of Ecology regulations, effective from January 1, 2025. It is
essential to follow these guidelines to ensure environmental protection and
regulatory compliance.
Installation
- Ensure the product is placed in a well-ventilated area.
- Connect the product to the appropriate power source as indicated in the user manual.
- Follow any specific installation instructions provided by the manufacturer.
Operation
- Power on the product using the designated power button.
- Adjust settings as needed based on your requirements.
- Monitor the product for any unusual behavior and refer to the user manual for troubleshooting steps if necessary.
Maintenance
- Regularly clean the product using a soft, damp cloth.
- Avoid using harsh chemicals or abrasive materials that may damage the product.
- Schedule periodic maintenance checks as recommended by the manufacturer.
INTRODUCTION
HFC REGULATIONS FROM WA DEPT. OF ECOLOGY
In November 2023, Washington State’s Department of Ecology finalized new
regulations necessary to meet emissions reductions under the state’s
Hydrofluorocarbons (HFC) – Emissions Reduction law. The new HFC refrigerant
regulations affect both existing and new food retailing stores.
“New refrigeration equipment” means any refrigeration equipment or system…that is one of the following:
- (a) New construction in a new facility;
- (b) An addition or modification that increases the nominal compressor capacity of a system in an existing facility;
- (c) New construction in an existing facility not previously used for cold storage, retail food refrigeration, commercial refrigeration, industrial process refrigeration, or ice rinks; or
- (d) A system in an existing facility used for commercial refrigeration or industrial process refrigeration that is modified such that the system undergoes cumulative replacements of 75 percent or more of its evaporators (by number) and 100 percent of its compressor racks, condensers, and connected evaporator loads.
See table on next page for GWP values on commonly used and new refrigerants
EXISTING FACILITIES
EXISTING FACILITIES – REFRIGERANT MANAGEMENT PROGRAM
Ecology has also created a refrigerant management program like
California’s. This includes the following parts:
- Registration and labeling
- Leak detection and monitoring
- Leak repair requirements
- Retrofit or replacement plans for leaking equipment
- Annual reporting and recordkeeping requirements
The table at the bottom summarizes the registration, labeling, and leak
detection requirements.
Annual facility reports are due on March 15, each year following the year the
facility is registered.
LEAK RATE THRESHOLDS
- The owner/operator of a facility with a system that exceeds the 12-month rolling average leak rate thresholds in the table at right must notify Ecology by email at HFC@ecology.wa.gov within 30 days of determining the exceedance, followed by leak repair verification tests as required.
- If a leak rate threshold is exceeded and the leak is not repairable, then the owner/operator will be required to submit a retrofit/retirement plan to Ecology within 90 days of the last repair verification test failure.
GWP COMPARISON OF COMMON REFRIGERANTS
REFRIGERANT MANAGEMENT
REFRIGERANT MANAGEMENT PROGRAM DETAILS
Link to Washington’s HFC Rule Informational Guidebook:https://apps.ecology.wa.gov/publications/documents/2314025.pdf
CONTACT
- Hussmann Corporation
- ADDRESS: 12999 St. Charles Rock Rd. Bridgeton, MO 63044-2483
- Ph: 314.291.2000
- www.hussmann.com
©2024 Hussmann Corporation
Frequently Asked Questions
- Q: Is this product compliant with other state regulations?
- A: The product is specifically designed to comply with WA Dept. of Ecology regulations. It is recommended to check with local authorities for compliance with regulations in other states.
- Q: What should I do if the product malfunctions?
- A: In case of any malfunction, refer to the user manual for troubleshooting steps. If the issue persists, contact customer support for further assistance.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>