Macurco TXP-T40 Fixed Gas Monitor Instructions
- June 1, 2024
- MaCURCO
Table of Contents
Macurco TXP-T40 Fixed Gas Monitor
Product Information
Specifications:
- Brand: Macurco
- Model: TXP-T40
- Type: TracXPTM Industrial Gas Detector
- Operating Range: Breathing Zone (4-6 feet)
- Mounting Height: 12 inches above the floor
Product Usage Instructions
Installation:
- Determine the appropriate mounting location for the TXP-T40 detector based on the breathing zone (4-6 feet) and 12 inches above the floor.
- Connect the calibration tubing to the splash guard and run it to the TXP-T40 using a 1/4″ ID Teflon tubing.
- Power and Modbus RTU cabling should travel to/from the T40 in a 3/4″ conduit as a typical setup.
Usage:
- Ensure the TXP-T40 detector is properly calibrated and powered.
- Position the detector in the desired location within the specified range.
- Monitor gas levels as indicated by the detector’s readings.
Maintenance:
- Regularly check and replace calibration tubing if necessary.
- Clean the detector and surrounding area to ensure accuratereadings.
FAQ
- Q: Can remotes be mounted far away from the detector?
- A: Yes, remotes can be mounted several hundred feet or more away from the detector for flexibility in installation.
- Q: Are there limitations on the combinations of detectors and remotes?
- A: There are various possible combinations not shown in the manual. Contact a qualified TracXP representative for assistance indesigning a setup tailored to your needs.
Installation Instruction
All drawings are for reference only. Electrical diagrams/drawings must be reviewed and approved by a local governing authority prior to installation. Macurco makes no representation or warranty concerning wiring diagrams/drawings, and you are to relysolely on the recommendations and requirements of the local governing authority.
Macurco Inc.
- 1504 West 51st Street
- Sioux Falls, SD 57105
- United States of America
- 1-877-367-7891
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>