reolink P750 16MP PoE Outdoor Camera User Guide
- June 1, 2024
- reolink
Table of Contents
Item No. : P750
Quick Start Guide
Apply to: Reolink Duo 3 PoE
@ReolinkTech
What’s in the Box
Camera Introduction
NOTE: Actual camera appearance and components are subject to the model you purchased.
Connection Diagram
Before initial setup, follow the steps below to connect your camera.
- Connect the camera to a PoE injector with an Ethernet cable.
- Use the power adapter to power on the PoE injector and connect it to your router.
NOTE: You can power the camera with a PoE switch, PoE injector, Reolink PoE NVR or a DC 12V power adapter(not included in the package).
Set up the Camera
Download and launch the Reolink App or Client software, and follow the onscreen instructions to finish initial setup.
• On Smartphone
Scan to download the Reolink App.
https://reolink.com/wp-json/reo-v2/app/download
• On PC
NOTE:
• If you are connecting the PoE camera to a Reolink PoE NVR, please setup the camera via the NVR interface.
Mount the Camera
Installation Tips
- Do not face the camera towards any light sources.
- Do not point the camera towards a glass window. Or, it may result in poor image quality because of the window glare by infrared LEDs, ambient lights or status lights.
- Do not place the camera in a shaded area and point it towards a well-lit area. Or, it may result in poor image quality. To ensure best image quality, the lighting condition for both the camera and the capture object shall be the same.
- To ensure better image quality, it’s recommended to clean the lens with a soft cloth from time to time.
- Make sure the power ports are not directly exposed to water or moisture and not blocked by dirt or other elements.
- With IP waterproof ratings, the camera can work properly under conditions like rain and snow. However, it doesn’t mean the camera can work underwater.
- Do not install the camera at places where rain and snow can hit the lens directly.
- The camera may work in extreme cold conditions as low as -25°C. Because when it is powered on, the camera will produce heat. You may power on the camera indoors for a few minutes before installing it outdoors.
- Try to keep the left lens level with the right lens.
Mount the Camera to the Wall
Drill holes in accordance with the mounting hole template. Secure the mounting
plate to the wall with the upper two screws and hang the camera on it. Then
lock the camera in position with the lower screw.
NOTE: Use the drywall anchors inclued in the package if needed.
To get the best field of view, loosen the adjustment screw on security mount
and turn the camera.
Stiffen the adjustment screw to lock the
camera.
Mount the Camera to Ceiling
Drill holes in accordance with the
mounting hole template. Secure the mounting plate to the ceiling with the
upper two screws and hang the camera on it. Then lock the camera in position
with the lower screw.
To get the best field of view, loosen
the adjustment screw on security mount and turn the camera.
Stiffen the adjustment screw to lock the
camera.
Troubleshooting
Camera is not Powering on
If your camera is not powering on, pleasetry the following solutions:
- Make sure your camera is powered on properly. The PoE camera should be powered by a PoE switch/injector, a Reolink NVR or a 12V power adapter.
- If the camera is connected to a PoE device as listed above, connect it to another PoE port and check again.
- Try again with another Ethernet cable.
Picture is not Clear
If the picture from the camera is not clear, please try the following
solutions:
- Check the camera lens for dirt, dust or spiderwebs, please clean the lens with a soft, clean cloth.
- Point the camera to a well-lit area, the lighting condition will affect the picture quality a lot.
- Upgrade the firmware of your camera to the latest version.
- Restore the camera to factory settings and check out again.
Specification
General
Dimension: 195x 103x 56 mm
Weight: 680g
Operating Temperature: -10°C~+55°C (14°F~131°F)
Notification of Compliance
FCC Compliance Statement
This device complies with Part 15 of the
FCC Rules. Operation is subject to the following two conditions:(1)this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
ISED Compliance Statements
This Class B digital apparatus complies with Canadian ICES-003.
Simplified EU Declaration of Conformity
Reolink declares that this device is in compliance with the essential
requirements and other relevant provisions of EMC
Directive 2014/30/EU and LVD 2014/35/EU.
Correct Disposal of This Product
This marking indicates that this product should not be disposed with other
household wastes. throughout the EU. To prevent possible harm to the
environment or human health from uncontrolled waste disposal, recycle it
responsibly to promote the sustainable reuse of material resources. To return
your used device, please use the return and collection systems or contact the
retailer where the product was purchased. They can take this product for
environmentally safe recycling.
Limited Warranty
This product comes with a 2-year limited warranty that is valid only if purchased from Reolink Official Store or a Reolink authorized reseller.
Terms and Privacy
Use of the product is subject to your agreement to the Terms of Service and Privacy Policy . Keep out of reach of children.
REOLINK INNOVATION LIMITED
FLAT/RM 705 7/F FA YUEN COMMERCIAL BUILDING 75-77 FA YUEN
STREET MONG KOK KL HONG KONG
CET PRODUCT SERVICE SP. Z O.O.
Ul. Dluga 33 102 Zgierz, Polen
CET PRODUCT SERVICE LTD.
Beacon House Stokenchurch Business Park,
Ibstone Rd, Stokenchurch High Wycombe,
HP14 3FE, UK
December 2023
QSG1_A
58.03.006.0096
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>