LED WORLD MN20-X12C-5PWF22ABKRGBW200 Strip to Power Clear Connector Installation Guide

June 1, 2024
LED WORLD

RGBW COB Strip to Power Clear Connector
Model: MN20-X12C-5PWF22ABKRGBW200

Kit comes with 4pcs of connectors. 2 Front connectors and 2 Back connectors
CAUTION: Max 3 Amps 12/24VDC (low voltage). Use only with Class 2 power supply. Indoor dry location use.
For use only with LED World’s type A 12mm wide RGBW LED COB Strips. Not to be used with Type B or C (Strips that have covers or coatings).
Important Note: Check the Polarity and make sure that connector contact points are directly over (and centered) the LED Flex Strip connector pads. Do not connect LED strips at soldered contact points.LED WORLD MN20-X12C-
5PWF22ABKRGBW200 Strip to Power Clear Connector

INSTALLATION STEPS

LED WORLD MN20-X12C-5PWF22ABKRGBW200 Strip to Power Clear Connector -
INSTALLATION STEPS 1

Remove the wax paper from back of the LED COB Strip. Look for cut mark line| Cut the LED COB Strip exactly along the cut mark line. Failure to cut straight may result in connection failure| Check the polarity as shown in above diagram before inserting into connector. Note: Connector can be used once
LED WORLD MN20-X12C-5PWF22ABKRGBW200 Strip to Power Clear Connector -
INSTALLATION STEPS

Make sure that strip is inserted all the way in| Complete the connection using plyers. Make sure cap is locked at base of connector| Test Connection. Wiggle gently.

LED World Inc. | #130 10615 48 ST SE | CALGARY, AB T2C 2B7 | CANADA | Version 1.0 – 01/17/2024
Copyright @2024 LED WORLD INC™. All Rights Reserved. We are not responsible for errors or omissions.
Product and specifications subject to change without notice.
Registered trademarks are owned by their respective registers, or licensee(s).

References

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

LED WORLD User Manuals

Related Manuals