PERFORMANCE DIY 12-15-23 Paver Coat Certified Instruction Manual

PERFORMANCE DIY 12-15-23 Paver Coat Certified

Specifications

• Best application time: Morning or evening
• Avoid direct sunlight during the application
• Non-skid additive for slip-resistant surface
• Industry standard OSHA 0.5 coefficient friction

Product Usage Instructions

Step 1: Preparation

Ensure the surface is clean and dry before application.

Step 2: Mixing

Shake the can well before opening. Pour the contents into a roller tray and mix for 1 minute using a mechanical mixer.

Step 3: Application

Roll out the product evenly in one direction using a roller. Alternatively, you can apply the product through a pump sprayer for larger areas.

Step 4: Finishing Touches

If needed, apply lesser amounts in specific areas for additional coverage. Back roll a second time for a smooth finish.

FAQ

• Q: Can I apply the product in direct sunlight?
  • A: It is recommended to apply the product in the morning or evening and avoid direct sunlight for best results.
• Q: How do I achieve a slip-resistant surface?
  • A: Use the PerformanceDIY.com non-skid additive as per industry standards to create a proper recommended OSHA 0.5 coefficient friction slip-resistant surface.

Product Result

Before

After

Contact

• Monday-Friday 9-5PM
• Tech Support Saturday 11-3PM EST
• 800-841-5580 EST
• www.PerformanceDIY.com

Using Instruction

Application is best in the morning or evening. Do not apply product in direct sunlight.

• Step 1:
  • Shake can before opening.
• Step 2:
  • Pour contents into a roller tray. Mix for 1 minute using mechanical mixer.
• Step 3:
  • Roll out evenly in one direction. (PerformanceDIY.com Paver-Coat can also be applied through a pump sprayer)
• Step 4:
  • Re-roll in opposite direction 5-10 minutes after application. If you desire to have aluminum oxide nonskid added to the floor broadcast aluminum oxide non-skid over the floor in lesser amounts (only in the previous section which has been back rolled a 2nd time).Taking a pinch amount apply by throwing the non-skid into the air a minimum of 5′ or higher. Re-bounding the non-skid off the ceiling is a good idea to get even coverage.
• Note:
  • Aluminum oxide will make the floor more slip resistant but will make it harder to clean; it should be used according to your desired needs. PerformanceDIY.com non-skid additive is industry standard and accepted means for creating a proper recommended OSHA 0.5 COEFFICIENT FRICTION slip resistant non-skid surface.

169 N. Gratiot

• Mt. Clemens, MI 48043
• O: 800-841-5580. F: 586-468-844
• PerformanceDIY.com

Surface Coatings

• Industrial & Commercial
• Garage
• Basement
• Deck & Patio
• Driveways
• Paver Coating
• Counter Tops
• Concrete Patch
• Crafts

References

• PerformanceDIY - DIY Certified Epoxy & Polyaspartic Coating kits
• PerformanceDIY - DIY Certified Epoxy & Polyaspartic Coating kits

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>