DIY Metallic-Coat Certified Kit for Counter Tops Instruction Manual

June 1, 2024
DIY

Metallic-Coat
Certified Kid for Counter Tops
Installation Instructions
12-15-23

Metallic-Coat Certified Kit for Counter Tops

DIY Metallic Coat Certified Kit for Counter TopsMonday-Friday 9-5PM
Tech Support Saturday 11-3PM EST
800-841-5580 EST

DIY Metallic Coat Certified Kit for Counter Tops - qr
codewww.PerformanceDIY.com

STEP BY STEP INSTRUCTIONS: PREPARATION

Step 1:
Recommended but not necessary to work in a ventilated room; (do not work near heat or flames if using Poly 300 Polyaspartic clear). Clean surfaces; remove any debris from counter top areas. Mix part “A” Resin with metallic colorant for 2 minutes. Let stand for 24 hours.

Step 2:
Sand the surface with the supplied sanding paper. Wipe clean with rags to remove any sanding dust and debris. Fill fine cracks with PerformanceDIY.com caulk.

Step 3: Primer Coat
Pour all of Part “B” into large clean container. Pour all of Part “A” base coat (colored primer) into same container. Mix thoroughly for 3 minutes with the mixing tool for 3 minutes, paying close attention to all around the buckets sides and rising and lowering the mixing tool.

Step 4:
Using the supplied squeegee spread the base coating material evenly over the counter to area, clean the squeegee well with a rag and xylene, as you will need it in step 8: DO NOT SOAK IN XYLENE THIS WILL DESTROY THE SQUEEGEE. Using the supplied 4” roller, roll out the base coating material evenly over the counter top area and the outer perimeter. Use small torch to reduce bubbles by waving flame quickly over bubbled surface.

Step 5:
After 24 hrs. sand to remove any high areas or inconsistencies to create a smooth surface.
Application of PerformanceDIY.com Metallic-Coat

Step 6: Metallic-Coat
Pour all of Part “B” into large clean container. Pour all of Part “A” pre-mix metallic resin into same container. Mix thoroughly for 3 minutes with the mixing tool for 3 minutes, paying close attention to all around the buckets sides and rising and lowering the mixing tool.

Step 7:
Using the supplied 1/8” squeegee spread the Metallic-Coating material evenly over the counter to area, clean the squeegee well with a rag and xylene, as you will need it in step 8: DO NOT SOAK IN XYLENE THIS WILL DESTROY THE SQUEEGEE. Using the supplied 4” roller, roll out the base coating material evenly over the counter top area and the outer perimeter. Use a small torch to reduce bubbles.
Counter can be used within 24 hours. Careful use for 3 full days.
Optional: For higher abrasion/UV resistance we recommend Poly 300. This product can be applied up to 16 mils DFT and can be used either inside or outside.

Surface Coatings:

Industrial & Commercial Deck & Patio Concrete Patch
Garage Driveways Counter Tops
Basement Paver Coating Crafts

169 N. Gratiot • Mt. Clemens, MI 48043
O: 800-841-5580. F: 586-468-844
PerformanceDIY.com

References

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

DIY User Manuals

Related Manuals