cocoon CE220633 Camera Security System User Guide
- June 1, 2024
- COCOON
Table of Contents
Quick Start Guide
CE220633 02/2024
8 CAMERA
SECURITY SYSTEM
CE220633 Camera Security System
Note : We highly recommend reading the manual in full before testing and
installing your security system.
Test all connections are working before permanently installing DVR and
cameras. Position the DVR in a central location where all 8 cameras will
reach. If you are wanting to use your DVR via mobile and/or PC, install near
your router and refer to the user manual for further instructions on
installation and operation.
-
Connect each of the camera extension cables to the video and power connectors.
-
Connect the other end of the extension cables to the ports marked “VIDEO IN” on the back of the DVR.
-
Connect the 8-way power splitter to each of the extension cable power plugs.
-
Connect the included HDMI cable to the back of the DVR and connect the other end of the HDMI cable to your monitor or TV (not a computer or laptop).
NOTE : You must switch your TV or monitor to the correct INPUT once the DVR has been powered on. For example, HDMI1 -
Connect the mouse to the rear USB port.
-
Connect the power adaptor to the 8-way splitter and plug into an outlet. Switch the outlet on.
-
Connect the remaining power adaptor to the DVR and plug into a mains outlet. Switch the outlet on. The DVR will begin the boot sequence.
NOTE : Both the DVR and cameras operate “always on”. To turn the cameras or DVR off, switch off the power adaptors at the power outlet
After Sales Support
1300 320 178
www.cocoonproducts.com.au