Cocoon HE150277 Create 3D Pen User Guide
- June 12, 2024
- COCOON
Table of Contents
HE150277 Create 3D Pen
User Guide
UNPACK
Unpack your Cocoon Create 3D Pen from the packaging and check you have all of the components:
- Cocoon Create 3D Pen
- 3 x 3 Metre 1.75mm ABS filament
- 1 x Power Adaptor
- 1 x Getting Started Guide
- 1 x Instruction Manual
- 1 x Warranty card
CONNECT TO
POWER
Connect one end of the power adaptor to the power jack located at the end of the pen, then connect the other end to a mains power outlet and switch on. The Power Indicator LED will turn on.
HEATING THE 3D PEN
Press the Forward Button to begin heating the 3D Pen. The Heat Indicator LED
will turn red when the pen is being heated. Once the 3D Pen has reached the
pre-set temperature, the Heat Indicator LED will turn green.
NOTE : Refer to manual for temperature settings
TRIM FILAMENT
Cut your desired length filament and ensure the tips of both ends are flat.
INSERT
AND LOAD FILAMENT
Insert one end of the filament into the Filament Port. Press and hold the Forward Button to begin loading until filament is extruded from the nozzle.
DRAW!
Hold the Forward Button to extrude and draw. To stop, release the Forward
Button. You can change the speed of filament extrusion with the Speed Slider.
For ideas and templates visit cocooncreate.com.au
|
http://www.cocooncreate.com.au/3dpen
|
---|---|---
After Sales Support
1300 663 907
www.winplus.com.au
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>