VIRTUOX 920M Plus Patient Self Administered Overnight Oximetry Instructions

Table of Contents

VIRTUOX-920M-Plus-Patient-Self-Administered-Overnight-Oximetry-
PRODUCT

Product Name: 920M Plus Patient Self-Administered Overnight Oximetry
Monitoring Purpose: To monitor blood oxygen levels while asleep
Testing Facility: VirtuOx
Delivery Restrictions: Cannot assist with test instruction or performance per Medicare guidelines

Follow the prescribed test conditions.
Remove any fingernail polish and coverings from the finger to be used.
Attach the sensor to the device as instructed.
Attach the sensor to the index finger and secure it with tape or a Band-Aid.
Turn the device ON and check the numbers on the display.
Go to sleep and wear the device throughout the night.
Upon waking up in the morning, turn the device OFF and contact the DME courier for device pickup.

Q: Why do I need to stay awake during the first 10 minutes of the test?
A: Staying awake during the initial phase of the test helps establish a baseline oxygen level for accurate comparison during sleep.
Q: What should I do if the device display shows abnormal readings?
A: If you notice unusual readings on the device, contact VirtuOx immediately for guidance.

Patient Name……………………………… Reading ID…………………………………………

Your prescriber ordered this oximetry test to monitor your blood oxygen levels while you are asleep.
It is vital you closely follow these instructions to get the best results.
VirtuOx is the testing facility that will process the test results and send them to your prescriber. Per Medicare guidelines, the company that delivers the testing device to you cannot assist with the instruction or performance of the test.

DME Courier:………………………………………Phone……………………………………………..

VIRTUOX-920M-Plus-Patient-Self-Administered-Overnight-Oximetry-
FIG-1

To create the best outcome we would also like to ask a few subjective questions about your sleep and cardiac issues you may have.
Scan the below QR code with your smartphone.
Enter your information into a webpage.

IMPORTANT

TEST SETUP

Follow the test conditions above.
Remove any fingernail polish and coverings from the finger you will be using.
Attach the sensor to the device as shown below.
Attach the sensor to your index finger and apply tape or Band-Aid to secure the sensor to your finger.
Turn the device ON and see the numbers on the display.
Go to sleep and wear the device throughout the night.
When you wake up in the morning, turn the device OFF.
Then call the DME at the phone number above to pick up the device.

If the sensor falls off during the night:
- Replace the sensor on your finger. 2) Check to see if the oximeter is ON and displays numbers.
- If the oximeter is OFF, press the power button to turn it ON.
If the indicator light blinks yellow or red for several minutes:
- Reposition the sensor on the finger. 2) Continue the test.
If the low battery indicator is yellow:
Do not replace batteries. 2) Continue the test. 3) Advise DME when they pick up the equipment.