TKH PD950NW 5MP Pendant PTZ Camera User Guide

TKH SECURITY
PD950NW
5MP Pendant PTZ
camera with 40x zoom
Quick Start Guide

PD950NW 5MP Pendant PTZ Camera

Find additional manuals, the datasheet, the EU Declaration of Conformity, and the latest firmware for this product at: https://tkhsecurity.com/

Unpack

Note 1: Subject to modification. Actual product and accessories may differ in appearance.

Installation Notices

CAUTION:
Installation shall be performed by qualified personnel only.
Installation shall be in accordance with local procedures.
If you use an external power supply, contact TKH Security to make sure that the power supply has the proper power specifications.
Battery replacement shall not be applied in view of the risk of explosion. Make sure that the power supply complies with LPS requirements.
When installing the camera, hook up the camera with the anti-drop chain of the pendant to the anti-drop ring (see figure 1).
For more information, contact TKH Security.

Connectors

For the connector definitions, see table

NOTE:
It is not recommended to continuously (24/7) record with the micro-SD card, as the camera may not support long-term continuous data read/write. Contact the manufacturer of the micro-SD card for information regarding the reliability and the life expectancy.

Connector Definition

PoE+ connections
2| Power (AC24V)| AC24V power connection
3| Reset Button| Press the button with a proper tool for at least 20 seconds to restore the system.
4| Audio/Alarm I/O & RS-485| Audio/Alarm I/O & RS-485 connection
5| BNC| For analog video output
6| SD Card Slot| Insert the SD card into the card slot to store videos and snapshots. Do not remove the SD card when the camera is powered on.

Table 1 Connector Definition

Camera Cabling (1)

Power Connector (AC 24V)

Table 3 Pin definition for AC24V power connection

POWER RATING OF PD950NW
24VAC, 50-60Hz or 50/60Hz, 2.09A shall be supplied by power adapter. 55VDC, 0.91A shall be supplied by “PoE”.

Camera Cabling (2)

PoE and Ethernet cable connection
❑ The green link LED is lit when there is a good network connection.
❑ The orange network LED flashes to indicate that there is network activity.

NOTE:
In some cases, an ethernet crossover cable may be needed when connecting the camera directly to the PC. Check the status of the link indicator and the activity indicator LEDs. If the LEDs are unlit, check the LAN connection.
WARNING:
For “PoE” input connection, use only with UL listed I.T.E. with “PoE” output.
Description for the “PoE” is intended to be connected to not exposed (outside plant) networks or equivalent statement in installation instructions.

Audio/Alarm I/O and RS-485 connection

See the diagram and the pin definitions below for the Audio/Alarm I/O and RS-485 connection.

Table 3 Pin definitions for Audio/Alarm I/O and RS-485 connection

Accessing the camera

Auto detect with SDM2

1st time camera login

Install browser-based viewer

Browser-based Viewer

Figure 4 shows the main page of the IP camera user interface.

Note 1: If the IE web interface is not showing video, you might need to open your firewall or set the OCX protocol to RTP-over-RTSP(TCP).

References

• TKH Security - Home – TKH Security

Read User Manual Online (PDF format)

Download This Manual (PDF format)

Download this manual  >>