ai-tenitas T200 Bounty Hunter Wireless PEN User Manual
- June 1, 2024
- ai-tenitas
Table of Contents
ai-tenitas T200 Bounty Hunter Wireless PEN
Product Specifications
- Model: [Insert Model Number]
- Compliance: FCC Part 15
- Conditions: Harmful interference prevention
- Operation: Acceptance of interference
Product Usage Instructions
- It is important to adhere to FCC requirements to ensure proper operation and compliance.
- Any changes or modifications not approved by the responsible party could void the user’s authority to operate the equipment.
Device Operation
This device complies with Part 15 of the FCC Rules. To ensure optimal performance, please follow these conditions:
- This device may not cause harmful interference.
- The device must accept any interference received, including interference that may cause undesired operation.
FAQ
Q: What should I do if I encounter interference while using the device?
A: If you experience interference, try adjusting the positioning of the device or moving it away from potential sources of interference. If the issue persists, contact customer support for further assistance.
Q: Can I make modifications to the device for customization?
A: To maintain FCC compliance and warranty validity, refrain from making any modifications to the device without approval from the manufacturer. Unauthorized modifications may impact the device's performance and compliance.
Using Instructions
-
Voltage & Battery Power
-
Press the side button to start
-
Press the side button to stop
-
Ready to connect: Double click and hold the button (Keep holding after the second click) until it shows
“Ready to Connect” to enter APP pairing mode when on pause status Please note: No connection after 30 seconds will back to the working interface. -
APP is paired successfully
-
Foot pedal is paired successfully
-
APP& foot pedal is paired successfully
-
Ambient Light: Press the button while the screen facing down, perpendicular to the ground when on pause status. Supporting ten colours.
-
Adjust Voltage: Press and keep holding the button then change the angle to your ideal voltage.
-
Please confirm the marked point Turn left to lock
-
Please confirm the marked point Turn right to unlock
1.19-inch Round Full Color AMOLED Screen
TIPS: SHUT DOWN AFTER 45 MINUTES IN STANDBY MODE.
FCC STATEMENT
FCC Requirement
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions:
- this device may not cause harmful interference, and
- this device must accept any interference received, including interference that may cause undesired operation.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy, and if not installed and used under the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and the receiver.
- Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>