Ampeg PF-112HLF Speaker Cabinet Owner’s Manual
- June 1, 2024
- ampeg
Table of Contents
Ampeg PF-112HLF Speaker Cabinet
Product Usage Instructions
HF Compression Driver On / Off Switch
- To turn the HF Compression Driver ON, press the top of the rocker switch inwards.
- To turn it OFF, press the bottom of the switch inwards.
Cleaning Instructions
- The cabinet is covered with a durable, fabric-backed vinyl material.
- Clean it with a dry, lint-free cloth.
- Avoid spraying cleaning agents onto the cabinet and abrasive cleansers that could damage the finish.
System Block Diagram
- The system consists of a Compression Driver, an Eminence 8 Ohm Speaker, and a crossover.
- The cabinet has two parallel jacks.
FAQ
- Q: Can I use this speaker cabinet with any amplifier?
- A: The PF-112HLF Speaker Cabinet is designed to work with amplifiers within the recommended power range. Using an amplifier with a higher power output may cause damage to the cabinet.
What’s in the Box
- PF-112HLF Speaker Cabinet, Quick Start Guide.
Introduction
- The Ampeg PF-112HLF bass enclosure delivers the performance, looks and affordability of the popular Portaflex® Series in a compact, ported design that doesn’t disappoint.
- Featuring a single 12″ Eminence® driver and a selectable HF driver, the 8 Ω PF-112HLF is more than capable of handling 200 watts of power. The poplar cabinet design is rugged but still looks great with an Ampeg black diamond tolex and chrome logo. Plus, the integrated side handle makes carrying it into your next gig easy. Match with the PF-20T or PF-50T amplifier for the ultimate, compact, all-tube tone powerhouse—Ampeg Portaflex PF-112HLF.
- Like all Ampeg products, your PF-112HLF is designed by musicians and built using only the best components. Each cabinet is tested to confirm that it meets our specifications, and we believe that this cabinet is the absolute best that it can be.
- In order to get the most out of your new PF-112HLF speaker cabinet, please fully read this Owner’s Manual, as well as the Important Safety Instructions included with your cabinet, before you begin playing.
And thank you for choosing Ampeg.
Features
- Vintage Portaflex cabinet design
- Black, diamond pattern tolex
- Vintage B-15 grille cloth
- Rugged 15 mm poplar plywood enclosure
- 200W RMS power handling @ 8 Ω
- 1 x 12″ ceramic Eminence LF driver
- Selectable 1″ HF compression driver
- Ported for low-frequency extension
Rear Panel Connector Plate
-
1/4″ TS Full Range Input / Output Jacks: The jack plate features two 1/4″ jacks wired in parallel, allowing easy daisy-chaining from one speaker cabinet to another. Each of the jacks may be used as an input or a through connection.
Connect the Speaker Output of your amplifier to the cabinet’s Input jack using a good quality (non-shielded) speaker cable. Never use (shielded) instrument cables to connect speakers to an amplifier.
You can optionally utilize the unused jack as an output/through jack to connect a second 8 Ω speaker cabinet in parallel. This will present a total load of 4 Ω to the amplifier. -
1″ HF Compression Driver On / Off Switch: Press the top of this rocker switch inwards to turn the HF Compression Driver ON. Press the bottom of this switch inwards to turn the HF Compression Driver OFF.
System Block Diagram
Technical Specifications
- Frequency Response (+/-3 dB): 68 Hz – 14 KHz
- Usable Low Frequency (-10 dB): 49 Hz
- Impedance: 8Ω
- Power Rating: 200W RMS, 400W Peak
- Sensitivity: 96 dB SPL 1W/1m
- Maximum SPL: 122 dB
- Cabinet Construction: Rugged 15 mm Poplar Plywood Enclosure
- Speaker Specs: 1 × 12″ Ceramic Eminence Speaker 1 x 1″ HF Compression Driver
- Inputs/Outputs: Dual 1/4″ Parallel Jacks
- Size (H x W x D): 19.8 × 17.1 x 13.1 in / 503 x 434 x 333 mm (from handle to foot)
- Weight: 30.8 lb / 14.0 kg (approximately)
The cabinet is covered with a durable, fabric-backed vinyl material. Clean
with a dry, lint-free cloth. Never spray cleaning agents onto the cabinet.
Avoid abrasive cleansers which would damage the finish.
Ampeg continually develops new products and improves upon existing ones. For
this reason, the specifications and information in this manual are subject to
change without notice.
Warranty and Support
- Visit WWW.AMPEG.COM to…
- Identify warranty coverage provided in your local market. Please keep your
- sales receipt in a safe place.
- REGISTER your product.
- CONTACT Technical Support, or call 818-575-3600.
CONTACT
- www.ampeg.com
- Yamaha Guitar Group Inc.
- 26580 Agoura Road, Calabasas, CA 91302-1921 USA Rev. A
© 2019 Yamaha Guitar Group, Inc. All rights reserved.
Ampeg, the Ampeg logo, and Portaflex are trademarks or registered trademarks
of Yamaha Guitar Group, Inc. in the U.S. and/or other jurisdictions. Eminence
is a registered trademark of Eminence Speaker, LLC.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>