elna 2024 Embroidery and Darning Foot Instructions
- June 1, 2024
- Elna
Table of Contents
elna 2024 Embroidery and Darning Foot
INSTRUCTION MANUAL
EMBROIDERY AND DARNING FOOT
Ref: 200-349-022
1. Attach the darning foot to the presser bar with the lever(A) over the
needle clamp screw.
2. Draw an outline for darning onto the fabric with tailor’s chalk and Place
the fabric under the needle.
3. Lower the presser foot lifter to engage the needle thread tension.
4. At a medium speed, stitch along the marked outline with the desired zigzag
width, guiding the fabric carefully by hand.
5. After free hand embroidery is completed, raise the feed dog for normal
sewing.
Machine Settings
- Stitch : Zigzag stitch
- Thread tension : “Auto” or 3 – 5
- Stitch length : Any
- Stitch width : 0 – 7
- Feed dog: Down
Specifications:
- Product Name: Embroidery and Darning Foot
- Reference Number: 200-349-022
FAQ
Q: What type of stitches can be used with the Embroidery and Darning
Foot?
A: The recommended stitch type is zigzag stitch for optimal results.
Q: Can this foot be used for quilting purposes?
A: Yes, this foot can be used for quilting, darning, and embroidery tasks.
Q: Is it necessary to adjust the thread tension when using this foot?
A: For best results, it is recommended to set the thread tension to Auto or between 3 – 5 depending on the fabric and thread being used.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>