ADATA R050 Magnetic Power Bank Instruction Manual
- June 1, 2024
- ADATA
Table of Contents
**ADATA R050 Magnetic Power Bank Instruction Manual
**
Instruction
a) The power bank will generate heat when charging. Always charge in a
well ventilated area. Do not charge under pillows, blankets or on flammable
surfaces.
b) Keep the power bank away from heat sources, direct sunlight,
combustible gas, humidity, water or other liquids.
c) Do not disassemble, open, microwave, incinerate, paint or insert
foreign objects into the power bank.
d) Do not subject the power bank to mechanical shock such as crushing,
bending, puncturing or shredding. Avoid dropping or placing heavy object on
the power bank.
e) Do not short-circuit the power bank or store it in a receptacle where
it may be short-circuited by other metallic or conductive objects.
f) Do not operate the power bank if it has been wet or otherwise damaged,
to prevent against electric shock, explosion and/or injury. Contact the dealer
or authorized agent.
g) Power bank usage by children should be supervised.
h) Please read the operating instructions (including charging
instructions and information on the minimum and maximum operating
temperatures), supplied with this power bank.
Rechargeable Li-Polymer Magnetic Power Bank
A. Power On/Off key
B. USB-C: In/Output
C. LED Indicator
D. Wireless charging indicator light
E. Wireless charging area
F. Stand
Product Features
-
Battery Capacity: 3.85V / 19.25Wh
-
Rate Capacity: 5V / 3100mAh, 9V / 1600mAh
-
Input: USB-C: DC 5V / 3A, 9V / 2A 18W Max
-
Output: USB-C: DC 5V / 3A, 9V / 2.22A 20W Max
Wireless Charge: 5W / 7.5W / 10W / 15W -
Max Output: USB-C+Wireless Output: 15W
-
Charging time: 3 hours (when using a compatible DC 5V 2.0A adapter)
-
Dimensions: 105 x 67 x 13.9 mm / 4.0 x 2.6 x 0.5 inch
-
Weight: 148g / 5.2oz
-
Temperature: Operating Temp: 1°C to 45°C
Storage Temp: -10°C to 45°C
Storage Humidity: 40% to 70% RH
Max. Ambient temperature: 25°C
Power Display
Press the Power On/Off to display the power status.
Indicator
| Battery Status|
Wireless Charging Status
---|---|---
Light on
| Power On Indicator – Charge Leve
1%~25%
25%~50%
50%~75%
75%~100%
| Wireless charging activated
Flashing|
- Power bank is charging
- Low battery warning
|
If a foreign object is detected between power bank and device, the indicator will flash and wireless charging will not start.
Dim light
| If the LED indicator lights are dim after pressing the power key, please
charge the Power Bank immediately.
|
Wireless charging off
Operation
Charge Your Mobile Device
This product does not support
pass-through charging)
Use USB output ports to charge your device
Discharging
(Output)
Plug the USB cable into the Power Bank and press the power button to charge
your device.
Two devices can be charged simultaneously either with cables or wirelessly.
Charge the Power Bank
Use the USB-C port to charge the Power Bank from a computer or a compatible
charging device.
Charging
(Input)
The LED indicator blinks while the Power Bank charges] Cautions
- Use the USB-C cable to charge the Power Bank. The cable is for charging only, not for data transfer.
- Do not leave this product in an enclosed vehicle. Extreme heat and sunlight may damage the power bank.
- Do not expose the product to high temperatures or humid environments.
- Do not insert metal or foreign objects into the product, so as to avoid short-circuits and damage.
- Do not disassemble, damage, jolt, or burn the product. Do not subject it to heavy weight.
- Do not arbitrarily discard this product; recycle used batteries in accordance with local laws.
- If not used long-term, charge the device once every three months in order to maintain the battery lifespan.
- If the Power Bank is out of power (after pressing the power key and the LED indicator remains dim),to avoid of battery damage, immediately charge the Power Bank.
- Output current will vary depending on the input charge.
- Stop using the power bank if it has reached the end of its lifespan or exhibits swelling.
- Using ADATA brand or safety-certified data transfer cables and charging stations is recommended to ensure charging safety.
- Do not overcharge this product.
- Do not submerge this product or allow water into its internal workings to prevent the risk of short circuits.
Recycle old batteries properly
Warranty
ADATA warranty policy applies to all customers who purchased ADATA products
through authorized agents.
ADATA provides replacement or repair services for defective products within
the applicable warranty period.
Please note that ADATA is not responsible for providing repair or replacement
if damage is caused by the following:
- Damage caused by natural calamity or any inappropriate usage.
- Product has been repaired or taken apart by unauthorized technicians.
- The warranty label is altered, damaged or missing.
- Product serial number does not conform to our original system or the label has been damaged.
- Products purchased from unauthorized agents. This limited warranty covers only repairs or replacements of ADATA products. ADATA is not liable for any loss of data or any cost incurred from determining the source of system problems, removing, servicing or installing ADATA products.
For more information, visit the ADATA website : http://www.adata.com
FCC Statement
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more
of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help
This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions (1)this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.