BEEGROW FT22112804-02 Mud Flaps Splash Guards for Ford Bronco Accessories Installation Guide

BEEGROW FT22112804-02 Mud Flaps Splash Guards for Ford Bronco Accessories

MUD Flaps

ASSEMBLY

1.  Remove the original wheel eyebrows.
2. Remove the original car screws at the circled position.
3. Insert the accessory screw.
4. Attach accessories here as shown.
5.  As shown in the picture, install the bracket shown in the picture here.
6. Install with the circled screw at this location as shown.
7. Secure with the screws you just removed.
8.  Remove the two nuts at the mark.
9.  Remove the two nuts at the mark.
10. Align the holes of the picture bracket with the original car screws as shown in the picture.
11.  Fix with the original car screw cap.
12.  Take out the corresponding fender.
13.  Align the holes , install.
14.  Fix with the accessories shown.
15.  The installation is complete.
16. Install the wheel eyebrows, all installation is complete.
17.  The card bracket is shown in the figure.
18. Install the bracket on the other side.
19. Use accessory screws to fix.
20. Tighten with tools.
21. Remove the original car buckle.
22.  Open the lining.
23.  Insert the attachment buckle.
24. Corresponding to two hole positions
25.  Use a tool to align the buckle holes.
26.  Use accessory screws to fix.
27.  Use accessory screws to fix.
28.  Take out the corresponding fender and pull back the support for installation.
29.  Align the three holes.
30.  Use accessory screws to fix.
31. Installation Complete.

Read User Manual Online (PDF format)

Download This Manual (PDF format)

Download this manual  >>