Ingenuity 12189-ES ConvertMe Swing 2 Seat Portable Swing Raylan Instruction Manual

June 1, 2024
ingenuity

Ingenuity 12189-ES ConvertMe Swing 2 Seat Portable Swing Raylan

Ingenuity 12189-ES

INSTRUCTION MANUAL

ConvertMe Swing-2-Seat Portable Swing™ – Raylan™

IMPORTANT!

READ CAREFULLY AND KEEP FOR FUTURE REFERENCE

WARNING

FALL and STRANGULATION HAZARDS: Infants have suffered head injuries falling from swings and have strangled in straps.

  • ALWAYS use the restraint system. Adjust to fit snugly.

  • STOP using product when infant attempts to climb out (approximately 9 months).

  • In swing mode, DO NOT use this product once your child can sit up unaided or weighs more than 9 kg/20 lbs. DO NOT use this product if your child weighs less than 3kg/6 lbs. In stationary seat mode, stop using the product when baby starts trying to sit up.

  • Stay near and watch baby during use. This product is not safe for sleep or unsupervised use. If baby falls asleep, remove baby as soon as possible and place baby on a firm, flat sleep surface such as a crib or bassinet.

  • Never let the child sleep in this product.

  • DO NOT move or lift this product with the baby inside it. Never lift product using a toy bar as a handle.

  • ALWAYS place product on floor. Never use this product on an elevated surface (e.g. a table).

  • NEVER attach any additional strings or straps to product or toy bar.
    SUFFOCATION HAZARD: Babies have suffocated when seats tipped over on soft surfaces.

  • NEVER use on a bed, sofa, cushion, or other soft surface.
    Prevent Serious Injury or Death

  • NEVER leave the child unattended.

  • To avoid injury ensure that children are kept away when unfolding and folding this product.

  • Do not let children play with this product.

  • When using the USB cord, only use the one supplied with this swing.

  • Check the USB cord and wall adaptor regularly for damage. Do not use if any damage has occurred.

  • Use USB cord only with a 5 Volt/1 Amp (5 Watts) USB A wall adaptor.

  • The product shall only be used with a transformer for toys.

  • The transformer is not a toy.

  • This product is only to be connected to equipment bearing either of the following symbols:

  • Do not use extension cords.

CAUTION

  • This product contains small parts. Adult assembly required.
  • The provided USB cord is 183cm in length.
  • This product contains magnets.
  • Please read all instructions before assembly and use of the product.
  • Care should be taken in unpacking and assembly.
  • Examine product frequently for damaged, missing, or loose parts.
  • DO NOT use if any parts are missing, damaged, or broken.
  • Contact Kids2 for replacement parts and instructions if needed. Never substitute parts.
  • This product does not replace a cot or a crib. Should the child fall asleep, then it should be placed in a suitable cot or crib.

Battery Information

The vibration unit requires (1) size C/LR14 (1.5V) alkaline batteries (not included).

CAUTION: Follow the battery guidelines in this section. Otherwise, battery life may be shortened or the batteries may leak or rupture. To prevent battery leaks, which can burn skin and eyes:

  • Always keep batteries away from children.

  • Never mix old and new batteries, or batteries of different brands or types.

  • Always replace the entire set of batteries at one time.

  • Do not mix alkaline, standard, or rechargeable batteries.

  • Only batteries of the same or equivalent type as recommended are to be used.

  • Install the batteries so that the polarity of each one matches the markings in the battery compartment.

  • Do not short-circuit the batteries.

  • Do not store batteries in areas that have extreme temperatures (such as attics, garages, or automobiles).

  • Remove exhausted batteries from the battery compartment.
    Never attempt to recharge a battery unless it is specifically marked “rechargeable.”

  • Rechargeable batteries are to be removed from the toy before being charged.

  • Rechargeable batteries are only to be charged under adult supervision.

  • Dispose of used batteries immediately.

  • Please use the correct disposal method for batteries.

  • Remove batteries before putting the product into storage for a prolonged period of time.

  • Weak batteries cause erratic product operation, including distorted sound, dimming or failed lights, and slow or non-working motorized parts. Because each electrical component requires a different operating voltage, replace the batteries when any function fails to operate.

  • Do not dispose of product or batteries in fire, batteries may explode or leak.

This symbol indicates that the product is not to be disposed of in household waste as batteries contain substances that can be damaging to the environment and health. Contact local authority for recycling & collection information.

Care and Cleaning

  • Seat pad and headrest – Remove from frame. Fasten buckles on seat restraint and seat pad. Fasten all hook-and-loop patches to the corresponding patch. Machine wash with cold water, gentle cycle. No bleach. Tumble dry, using low heat.

  • Toy bar and toys – Wipe clean with a damp cloth and mild soap. Air dry.
    Do not immerse in water.

  • Frame – Wipe the metal frame with a soft, clean cloth and mild soap.

  • Storage – When putting swing away for storage, always store in a dry location, away from any heat sources, and out of the sun.

Parts List

No. Nr. No Qty. Sztuk. Qte Description
1 (2) MS Phillips Screw
2 I/1,) Headrest
3 (1) Rear Base Frame Assembly
4 (1) Left Front Base Frame
5 (1) Right Front Base Frame
6 (1) Control Panel Assembly
7 (1) Left Swing Frame Assembly
8 ,  l1  ,) Right Swing Frame Assembly
9 (1) Cross Arm Assembly
10 (2) Seat Tube
11 (1) Seat Pad
12 (1) Toy Bar with Toys
13 (1) Vibration unit
14 (1) USB A Cable

Not Included

Ingenuity 12189-ES

Ingenuity 12189-ES

Ingenuity 12189-ES

Ingenuity 12189-ES

Ingenuity 12189-ES

Ingenuity 12189-ES

Ingenuity 12189-ES

Ingenuity 12189-ES

TO OPERATE THE UNIT, CONNECT THE USB CORD (SUPPLIED) TO A 5V/ 1A USB A WALL CHARGER.

Using in the Seat Mode

Ingenuity 12189-ES

Using the Seat Restraint

Ingenuity 12189-ES

Ingenuity 12189-ES

Ingenuity 12189-ES

Using the Swing Control Module

Ingenuity 12189-ES

| Slide the Power Switch to power the swing.
---|---
| The Speed Selector provides 5 speed settings. To start the swing function, press the button until the flashing LED displays the desired setting. Gently push the seat to start the swing motion. When the speed setting is changed during swing motion, the LED will flash during this speed adjustment.
| Use the Swing Timer to turn OFF the swing automatically. Press the button to select the desired timer setting of 30, 45, or 60 minutes. If a timer setting is not chosen, the swing uses a default time of 90 minutes for auto-shutoff. To use the swing function after shutoff, press the Speed Selector.
| Press the Nature Sounds/Music Button to begin music and nature sounds playback. Auto-shutoff occurs after about 20 minutes.
| Push the Volume Control Switch as needed to turn off or adjust the volume for music and nature sounds.

Using Swing Function

Ingenuity 12189-ES

Storage and Travel

Ingenuity 12189-ES

Ingenuity 12189-ES

Using the Vibration Unit

To use the vibration function: Push the button to turn on or turn off the vibe unit.

FCC Statement / CAN ICES-3 (B) / NMB-3(B)

This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions:

1. this device may not cause harmful interference, and
2. this device must accept any interference received, including interference that may cause undesired operation.

WARNING: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation.

If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

  • Reorient or relocate the receiving antenna.
  • Increase the separation between the equipment and receiver.
  • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
  • Consult the dealer or an experienced radio/TV technician for help.

Specifications:

  • Product Name: ConvertMe Swing-2-Seat Portable SwingTM -RaylanTM
  • Brand: Ingenuity
  • Model Number: 12189-ES
  • Battery Requirement: (1) size C/LR14 (1.5V) alkaline batteries (not included)

FAQ:

Q: Can I use rechargeable batteries with this swing?

A: It is recommended to use size C/LR14 (1.5V) alkaline batteries for optimal performance. Rechargeable batteries may not provide the same level of power.

Q: How do I clean the seat pad?

A: Remove the seat pad according to the instructions provided in the manual and hand wash it with mild soap and water. Allow it to air dry completely before reattaching.

Find us on Facebook and Instagram @ingenuitybaby

ingenuitybaby.com

References

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals