ingenuity 12055-ES ConvertMe Swing 2 Seat User Manual
- May 15, 2024
- ingenuity
Table of Contents
ingenuity 12055-ES ConvertMe Swing 2 Seat
Product Specifications
- Brand: Ingenuity
- Model: 12055-ES
- Website: ingenuitybaby.com
- Battery Requirement: (1) size C/LR14 (1.5V) alkaline batteries(not included)
IMPORTANT! READ CAREFULLY AND KEEP FOR FUTURE REFERENCE
WARNING: FALL and STRANGULATION HAZARDS: Infants have suffered head
injuries falling from swings and have been strangled in straps.
-
ALWAYS use the restraint system. Adjust to fit snugly.
-
STOP using the product when the infant attempts to climb out (approximately 9 months).
-
In swing mode, DO NOT use this product once your child can sit up unaided or weighs more than 9 kg/20 lbs. DO NOT use this product if your child weighs less than 3kg/6 lbs. In stationary seat mode, stop using the product when the baby starts trying to sit up.
-
Stay near and watch the baby during use. This product is not safe for sleep or unsupervised use. If the baby falls asleep, remove the baby as soon as possible and place the baby on a firm, flat sleep surface such as a crib or bassinet.
-
Never let the child sleep in this product.
-
DO NOT move or lift this product with the baby inside it. Never lift a product using a toy bar as a handle.
-
ALWAYS place the product on the floor. Never use this product on an elevated surface (e.g. a table).
-
NEVER attach any additional strings or straps to the product or toy bar.
SUFFOCATION HAZARD: Babies suffocate when seats are tipped over on soft surfaces. -
NEVER use on a bed, sofa, cushion, or other soft surface.
Prevent Serious Injury or Death -
NEVER leave the child unattended.
-
To avoid injury ensure that children are kept away when unfolding and folding this product.
-
Do not let children play with this product.
-
When using the USB cord, only use the one supplied with this swing.
-
Check the USB cord and wall adaptor regularly for damage. Do not use if any damage has occurred.
-
Use a USB cord only with a 5 Volt/1 Amp (5 Watts) USB A wall adaptor.
-
The product shall only be used with a transformer for toys.
-
The transformer is not a toy.
-
This product is only to be connected to equipment bearing either of the following symbols:
-
Do not use extension cords.
-
CAUTION: This product contains small parts. Adult assembly is required.
IMPORTANT
- The provided USB cord is 183cm in length.
- This product contains magnets.
- Please read all instructions before assembly and use of the product.
- Care should be taken in unpacking and assembly.
- Examine the product frequently for damaged, missing, or loose parts.
- DO NOT use if any parts are missing, damaged, or broken.
- Contact Kids2 for replacement parts and instructions if needed. Never substitute parts.
- This product does not replace a cot or a crib. Should the child fall asleep, then it should be placed in a suitable cot or crib.
**Battery Information
**
The vibration unit requires (1) size C/LR14 (1.5V) alkaline batteries (not included).
CAUTION: Follow the battery guidelines in this section. Otherwise, battery life may be shortened or the batteries may leak or rupture. To prevent battery leaks, which can burn skin and eyes:
- Always keep batteries away from children.
- Never mix old and new batteries or batteries of different brands or types.
- Always replace the entire set of batteries at one time.
- Do not mix alkaline, standard, or rechargeable batteries.
- Only batteries of the same or equivalent type as recommended are to be used.
- Install the batteries so that the polarity of each one matches the markings in the battery compartment.
- Do not short-circuit the batteries.
- Do not store batteries in areas that have extreme temperatures (such as attics, garages, or automobiles).
- Remove exhausted batteries from the battery compartment.
- Never attempt to recharge a battery unless it is specifically marked “rechargeable.”
- Rechargeable batteries are to be removed from the toy before being charged.
- Rechargeable batteries are only to be charged under adult supervision.
- Dispose of used batteries immediately.
- Please use the correct disposal method for batteries.
- Remove batteries before putting the product into storage for a prolonged period.
- Weak batteries cause erratic product operation, including distorted sound, dimming or failed lights, and slow or non-working motorized parts. Because each electrical component requires a different operating voltage, replace the batteries when any function fails to operate.
- Do not dispose of products or batteries in a fire, batteries may explode or leak.
This symbol indicates that the product is not to be disposed of in household waste as batteries contain substances that can be damaging to the environment and health. Contact local authority for recycling & collection information.
Care and Cleaning
- Seat pad – Remove from frame. Fasten the buckles on the seat restraint and seat pad. Fasten all hook-and-loop patches to the corresponding patch. Machine wash with cold water, gentle cycle. No bleach. Tumble dry, using low heat.
- Headrest – Fasten all hook-and-loop patches. Machine wash with cold water, gentle cycle. No bleach. Air dry flat.
- Toy bar and toys – Wipe clean with a damp cloth and mild soap. Air dry.
Do not immerse in water.
- Frame – Wipe the metal frame with a soft, clean cloth and mild soap.
- Storage – When putting the swing away for storage, always store it in a dry location, away from any heat sources, and out of the sun.
Parts List
Not included
- TO OPERATE THE UNIT, CONNECT THE USB CORD (SUPPLIED)
- TO A 5V/ 1A USB WALL CHARGER.
INSTALLATION INSTRUCTION
TO OPERATE THE UNIT, CONNECT THE USB CORD (SUPPLIED) TO A 5V/ 1A USB WALL
CHARGER.
Using INSTRUCTION
Using the Seat Mode
Using the Seat Restraint
Using the Swing Control Module
- Slide the Power Switch to power the swing.|
- The Speed Selector provides 5-speed settings. To start the swing function, press the button until the flashing LED displays the desired setting. Gently push the seat to start the swing motion. When the speed setting is changed during swing motion, the LED will flash during this speed adjustment.
- Use the Swing Timer to turn OFF the swing automatically. Press the button to select the desired timer setting of 30, 45, or 60 minutes. If a timer setting is not chosen, the swing uses a default time of 90 minutes for auto-shutoff. To use the swing function after shutoff, press the Speed Selector.
- Press the Nature Sounds/Music Button to begin music and nature sounds playback. Auto-shutoff occurs after about 20 minutes.
- Push the Volume Control Switch as needed to turn off or adjust the volume for music and nature sounds.
Using Swing Function
Storage and Travel
Using the Vibration Unit
To use the vibration function: Push the button to turn on or turn off the vibe unit.
FCC Statement
FCC Statement / CAN ICES-3 (B) / NMB-3(B)
This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions:
- this device may not cause harmful interference, and
- this device must accept any interference received, including interference that may cause undesired operation.
WARNING : Changes or modifications to this unit not expressly approved by
the party responsible for compliance could void the user’s authority to
operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, under Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses, and can radiate
radio frequency energy and, if not installed and used under the instructions,
may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a
particular installation.
If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the
following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and the receiver.
- Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
FAQ
Frequently Asked Questions
- Q: What type of batteries does the product require?
- A: The product requires (1) size C/LR14 (1.5V) alkaline batteries, which are not included in the package.
- Q: How do I adjust the swing speed?
- A: You can adjust the swing speed by using the Speed Selector Button on the Swing Control Module.
- Q: Can I clean the product with water?
- A: No, it is recommended to clean the product with a dry cloth and keep it away from heat sources and direct sunlight.
Find us on Facebook and Instagram @ingenuitybaby
Retrouvez-nous sur Facebook et Instagram @ingenuitybaby
- Toys
- Activity Gyms
- Bouncers
- Rockers
- Swings
- Bassinets
- Playards
- High chairs
- Booster Seats
MANUFACTURED FOR
USA 30305 • 1-800-230-8190
IMPORTED BY
- SUMMER INFANT (USA) INC. 1275 PARK EAST DRIVE, WOONSOCKET, RI 02895 USA • 1-401-671-6551
- KIDS2 CANADA CO. PO BOX 54059, RPA LAWRENCE PLAZA, TORONTO, ON. M6A 3B7
- KIDS2 AUSTRALIA PTY LIMITED CASTLE HILL, NSW AUSTRALIA 2154 • (02) 9894-1855
- KIDS2 JAPAN K.K. c/o ARK Outsourcing KK 4-3-5-704, Ebisu, Shibuya-ku, Tokyo, Japan 150-0013 • (03) 5322-6081
- KIDS2 UK LTD. GROUND FLOOR, SUITE A1A, BREAKSPEAR PARK, BREAKSPEAR WAY, HEMEL HEMPSTEAD, HP2 4TZ • +44 01582 816 080
- KIDS2 EUROPE BV 5 KEIZERS, KEIZERSGRACHT 287, 1016 ED AMSTERDAM, NETHERLANDS • +31 20 2410934 KIDS2 US MÉXICO S.A. DE C.V. • (55) 5292-8488
ingenuitybaby.com
MADE IN CHINA
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>