Edostory 12V 3-Speeds Electric Ride On Bumper Car Instruction Manual

Edostory 12V 3-Speeds Electric Ride On Bumper Car

ATTENTION
This product is packed with the battery disconnected. Connect the battery before use. This manual contains important safety, performance and maintenance information. Read the manual before allowing your child to ride your new electric ride-on toy. Keep the manual handy for future reference.

Safety Instruction

When using electrical product, basic safety precaution should always be followed including the following.

Read all Instruction before use

• To Protect against electrical shock, do not immerse cord, charger, transformer, battery, or the product in water or other liquid.
• Only use charging devices, transformer, and battery provided or recommended by the manufacturer.
• For your children’s safety, the product should by assembled by adult.
• This toy is not intended for children below 18 months .
• Close supervision is necessary when your children is using the product.
• Unlatch the battery if not used for a long time.
• Do not use this product as a traffic tool.
• Do not use this product on public road, raceway, by the swimming pool, or at any potential dangerous places.
• Do not use this product on slippery surface.
• Always keep hands, hair, and clothing away from moving parts.
• Maximum users weight for this product is 66 lb/ 30 kg.
• Do not change, modify or add any electrical wiring on this product.
• Avoid using this product in tight environment to prevent damage to the product or injury to the user.
• Do not use this product in the dark. Only operate this product during daytime or well lit area.
• For your chlid’s safety, pis make sure fasten the seat belt when using this product.

Note:

1. When charging, you mush turn off the power switch.
2. It is recommended to charge 8-12 hours before the first use, but not more than 20 hours.
3. When the speed of the vehicle is significantly slowed during normal driving, the battery power is insufficient. Please charge it in time.
4. Please charge 6-8 hours after each use, but do not exceed 10 hours.

Parts and Feature

1. Vehicle Body
2. Seat Cover
3. Seat Belt
4. Control Stick
5. Power Button
6. Music Button *4
7. AUX
8. USB
9. Charging Port
10. Remote Control

User Instruction

1. Unscrew the screw and remove the seat cover. Connect the battery terminal.(Red to red, black to black)
2. Replace the seat cover and tighten the screws.
3. lnstall the joystick hand.
4. Secure the joystick with screws.
5. Press the backrest down into the slot.
6. installation is complete.

Operating the vehicle

• Press the power switch to turn on the vehicle.
• Push or pull the control sticks to move the vehicle.
• Release the control stick back to the center position to stop.

Using the remote control
The remote control should only be used by adult. The first time you use ( or replace a battery), you need to code it. This product has the characteristics of automatic code alignment.

The specific operations are as follows:

1. Insert batteries into the remote control, and the first light of it begins to flicker.
2. Turn on the power supply of the baby carrier, and the three indicators are all on, that means success.

Control the vehicle
For your chi id’s safety, pis make sure fasten the seat belt when using this product. Press the ” S /M ” button is to governing speed. Press the ” P ” button to enable emergency brake. All running function will be disabled once the button is pressed. Press ” P ” button again to disable.
NOTE: The remote control will goes into power saving mode if not used after 10 seconds.
WARNING

• Close supervision is needed when children is operating the vehicle.

Charging the battery

• Plug the charger to the charging port.
• Fully charge the battery for 6-8 hours.
• Do not charge the battery for more than 10 hours.
• Make sure the battery and charger is not damaged. Do not charge if any sign of wear or damage is found.

Care and Maintenance

• Check the product regularly and make sure there is no missing or loose parts.
• Re-tighten any loose parts if necessary.
• Make sure there is no cracked or broken plastic parts.
• When not using store the product away from heat source, cover it with a tarp and away from wet weather.
• Turn off the product and disconnect the battery if the product is not use for a long period of time.
• Clean the vehicle with a cloth. Use a non-wax furniture polish to restore shine to plastic parts.
• Do not use abrasive cleaner.
• Do not wash the product with a hose or immerse any parts in water or other liquid.
• Occasionally use lightweight oil to lubricate moving parts.

Troubleshooting

connectors are firmly connected. Contact Customer service if necessary
“Dead spot” on motor| Contact customer service
Loud grinding sound or clicking sound from the motor or gear box| Damaged motor or gear box| Contact customer service
Battery does not charge| Disconnected/ Badly connected battery| Reconnect the battery
Disconnected/ Badly connected charger| Make sure the charger is firmly plugged into the power source and connected to the charging port
Charger not working| Contact customer service
Charger feels warm with charging| Normal|
Vehicle does not move| Low Battery| Fully charge the battery
---|---|---
Fuse Protection| Replace with a new fuse
Disconnected/ Badly connected battery| Reconnect the battery
Failed battery/ engine| Contact Customer Service
Vehicle does not run very long| Low Battery| Fully charge the battery
Old Battery| Replace battery if necessary
Vehicle runs very slow| Low Battery| Fully charge the battery
Old Battery| Replace battery if necessary
Vehicle is overloaded| Make sure user’s weight is under 60 lb/ 30 kg
Vehicle is being used in harsh environment| Avoid using the vehicle in harsh environment

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>