Ledvion LV20001_1 LED Lamp Tube Instruction Manual
- June 2, 2024
- Ledvion
Table of Contents
Ledvion LV20001_1 LED Lamp Tube
INTRODUCTION & WARRANTY
Thank you for selecting and buying Ledvion products. Leviton will serve you the best. Please read the instructions carefully before starting the installation and keep this manual handy for future reference. If you have any other queries, please contact our dealer or local vendor from whom you have purchased the product. They are retained and ready to serve you at your best. The warranty is valid for 2 years from the date of purchase. The warranty does not apply to damage caused by incorrect installation or abnormal wear and tear. The company gives no warranty against damage to any surface due to incorrect removal and installation of the product. The products are suitable for 10-12 Hours Daily operation. Usage of the product for 24 Hours a day would void the warranty. This product is warranted for manufacturing defects only. The LED tube can be used in hotels, offices, factories, conference rooms, meeting rooms, commercial complexes, residential buildings, schools, colleges, universities, hospitals, etc.
WARNING!
- Installation should only be done by a certified electrician
- Operation environment temperature: from -20°C to +40°C
- Do not use DC electricity
- Do not modify the fitting to be used with the LED tube
- Ledvion LED Tubes are NOT designed to be used in emergency operations.
- Ledvion LED Tubes are NOT designed to be used in emergency operations
- This lamp may not be suitable for use in all applications where a traditional fluorescent lamp has been used. The temperature range of this lamp
- is more restricted. In cases of doubt regarding the suitability of the application the manufacturer of this lamp should be consulted
- This lamp is designed for general lighting service (excluding for example explosive atmospheres)
- Do NOT use electronic ballasts. Ledvion LED tubes are not compatible with electronic ballast circuit.
- In order to use the electronic ballast fitting you must ensure to remove the electronic ballast from the fitting and rewire the circuit as per the new fitting installation as shown below. Ensure the installation and wiring is carried out by certified electrician
PACKING
- LED tube (1PC)
- Instruction Manual (1PC)
- LED starter included (1PC)
INSTALLATION INSTRUCTION
New Fitting Installation
- Installation should only be done by a certified electrician
- Switch Off the power
- Ensure the wiring diagram is followed as highlighted
- Insert Ledvion LED tube
- Switch On the power to test the light
Installation & Replacement of Fluorescent Lamo (Sinale Maanetic Ballast Circuit)
- Installation should only be done by a certified electrician
- Please refer to the wiring diagram for replacing the fluorescent tube on a single magnetic ballast circuit with a Ledvion LED tube
- Switch OFF the power
- Remove the existing fluorescent lamp
- Remove the existing fluorescent starter
- Insert LED T8 starter
- Insert LED Tube
- Switch ON the power
Wiring Diagram
BE CAREFUL WITH CONNECTING THE LED TUBE. ON THE TUBE IS DESCRIBED WHICH SIDE NOT TO POWER!
SYMBOLS
- This marking indicates that this product should not be disposed of with other household wastes.
- LED lamps suitable for 50-60Hz operation.
- Led lamps to be used in dry conditions or in a luminaire that provides protection.
- Caution, risk of electric shock.
- LED tubes are NOT suitable for dimming.
- Led tubes are not suitable for emergency operations.
TECHNICAL DATA
IN CASE ANY QUERY/ISSUE WITH THE PRODUCT, PLEASE REACH OUT TO US AT: SUPPORT@LEDVION.COM FOR MORE PRODUCT RANGES, INQUIRY PLEASE CONTACT OUR DISTRIBUTOR OR NEAREST DEALERS. LEDVION – 5692 DH SON EN BREUGEL – EKKERSRIJT 4304 – THE NETHERLANDS.
CONTACT
- Ledvion
- Ekkersrijt 4304
- The Netherlands
- www.ledvion.com
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>