LAMTTO CAM-E-B113 Mini Front and Rear View Camera Instruction Manual
- June 2, 2024
- Lamtto
Table of Contents
LAMTTO CAM-E-B113 Mini Front and Rear View Camera
Mini front and rear-view camera
CAM-E-B113
Product features
- Mini camera NTSC in metal housing (black)
- Cable-guided thread tube with counter nut
- System cable with throughput, e.g. for reverse signal
- Horizontal mount-under and vertical mount-on possible
- Mirroring can be switched off – suitable also as front camera
- Sensor type CMOS 1/4 inch HD NTSC low-light sensitive
- 800 TV lines
- Light sensitivity 0.01Lux
- Bezel F1.2
- Angle H=140°, V=105°, D=180
- Guide-lines width selectable between car and truck
- Guide-lines can be switched off
- Protection class IP69K
- Suitable for permanent operation (ACC)
- Operating voltage +12/24V (6 ~ 28V)
- Current consumption 50mA
- Video connection RCA male connector
- System cable of camera 4pin 3V
- Diameter of camera connector 5mm
- Total cable length 9.00m
- Operating temperature range -30°C to +75°C
- Dimensions camera without thread tube 25 x 27.7 x 22mm (w x d x h)
Installation
Note: If the camera is powered by reverse gear lamp signal, we recommend
to install a relay between the power supply of the reverse signal and the
power supply of the camera, to ensure a stable and uninterrupted power supply
and to avoid errors in the vehicle computer.
In case the isolation of the camera is harmed in the moisture section close to
the camera, it is mandatory to repair the isolation. Otherwise the camera will
inevitably become moist inside sooner or later.
Camera configuration (cut cable loops if required)
NavLinkz GmbH – Heidberghof 2 – 47495 Rheinberg – Germany – www.navlinkz.de – mail@navlinkz.de
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>