Ledvion LVS10016 Outdoor Solar LED Lamp Instruction Manual
- June 2, 2024
- Ledvion
Table of Contents
Ledvion LVS10016 Outdoor Solar LED Lamp
Please follow all instructions to operate. Save this manual for future reference.
Specification
| Brightness | 350LM |
|---|---|
| Output Power | 3W |
| Tradition I Power | 30W |
| LEDs | 5MD2835*21PC5 |
| Battery | 18650, 3.7V, 1200mAh, 4.44Wh |
| Mono Solar Panel | DC5.5V, 1.15W |
| PIR Sensor | 120′ / 6 Meters |
| Beam Angle | 140’*70′ |
| Work Modes | 2 Optional Work Modes |
| Charging Time | 5-6 hours strong sunshine to fully charge |
| Lighting Time | 35 hours |
| Installation Height | 2-4M |
| Lighting Area | 50 m’ |
| Housing Material | ABS+PC, anti-UV, antioxidant, VO fireproof |
| Lamp Dimension | 137.690.435.4mm |
| Packing | 1 Solar Lamp, 2Expansion Plugs & Screws, |
1 Measure Card, 1 User Manual
Warranty| 2 Years (1 Year for Battery)
Top Features
New Brick Design
Up & Down lighting
Solar Powered
Auto On/Off
TWO optional L1ghnng Modes
Long Lighting Time
Safe
IP65 Waterproof
Zero Electricity
Bills
PIR Detective
Cordless to Install
Battery Replaceable
2 Optional Work Modes
- Press the button 1st time, the upper light flashes once, lamp enters Mode A.
- Press the button 2nd time, the upper light flashes twice, lamp enters Mode B.
- Press the button 3rd time, the upper light flashes 3 times, lamp turns off.
Mode A
Lamp automatically lights up at night, automatically turns to full brightness when motion is detected in the range S6m, and then dims to lower brightness (upper light on, down light on) after 10 seconds of no motion.
ModeB
Lamp automatically lights up at night, automatically turns to full brightness when motion is detected in the range S6m, and then dims to lower brightness (upper light on, down light off) after 10 seconds of no motion.
Package Content
| PC*Lamp | 2PCS*Screws | lPC*Measure Card | lPC*User Manual |
|---|
| | |
Easy Installation
- Please use the measure card to mark holes position.
- Drill 2 holes(
6mm, depth 50mm) with a spacing of 80mm. - Fix the expansion plugs in the holes.
- Fix the screws into the expansion plugs, allow the screws to protrude slightly around 3-5mm.
- Turn on the lamp and set desired work mode.
- Hang the lamp on the screws to secure it to the wall.
Cautions
- This is a solar powered lamp, please install it in a location where can get efficient sunlight.
- Please note the lighting time depends on sunshine duration & work mode.
- Built-in intelligent IC is with over-charge and over-discharge protection, safe and durable.
- When the lamp is turned off, it still can get solar charging at day time.
- The lamp is equipped with an internal battery, which is replaceable. If any need, please contact the seller for support.
- Non-professionals please do not disassemble the lamp.
- Please do not dispose the battery with household garbage to avoid explosion.
Customer Support
Ledvion
Habraken 1205
5507 TB Veldhoven
The Netherlands
www.ledvion.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>