ACOUSTICS N35 In Ear Wireless Gaming Headset Stereo Low Latency Instruction Manual
- June 2, 2024
- ACOUSTICS
Table of Contents
ACOUSTICS N35 In Ear Wireless Gaming Headset Stereo Low Latency
Thank you for choosing the bluetooth headphones produced by our company, to enable you to use this product easily and happily. Please read this manual carefully before use
How to Wear
Put the “L” one in the left ear and put the ‘R” one in the right ear, then adjust the position until you feel comfortable.
How to Pair
- Power On: Take the earbuds from the charger case then it will connect to the connected device automatically. (Or long-press the earbuds 5 minutes)
- Power Off Put the earbuds back in the charger case and turn the bluetooth off on your phone. (Or long-press the earbuds for 5 minutes)
- Pairing connection: when the headset is picked up in the charging box, it will start automatically, and the traffic lights of the two headphones will turn on it will automatically enter the pairing state for the pair of ears. After painting, only one headset red and blue light flashing Turn on the blue device of the mobile phone to enter the search (display N35) and click Connect, as shown in the figure below
- Automatically Pairing: If the earbuds and phone paired before, just turn the bluetooth on your phone and take the earbuds out of the charger case, they will pair with them automatically.
Note: Charging the charger and earbuds before use, keeping there are no obstacles between the earbuds and the phone or it will be disconnected between them.
How to Operation
- Answer: Tap the earbud Once when is ringing.
- Reject: Tap the earbud Twice when is ringing.
- Play/Pause Music: Tap any earbud Once when is playing.
- Skip Songs: Tap the left earbud Twice to play the Prey song, Tap the right earbud Twice to play the Next song,
- Volume Control: Tap the left earbud 3 times to add volume, and Tap the right earbud 3 times to decrease volume.
- Both earbuds can be used separately.
- Touch four times to switch between game mode and normal mode.
- Long press Siri for 1.5 seconds.
How to Charging
- The Earbuds Battery: When the earbud’s battery is less than 10% the green light will blink twice and voice prompt low battery, each 2 minutes repeat once. Please charge soon.
- Seat charge : when the charge of the charging box is less than 10%, the green light flashes quickly, please charge it in time.
- Headset charging state : when the headset is put back into the charging box after use, the charging box will automatically detect the power of the headset For automatic charging, the charging indicator (green) flashes, the green light of the headset flashes during charging, and the red light after charging Keep on for 20 seconds and turn off the light.
- Charging status: when the charging box is low, the blue light of the charging box will flash. When the charging box is full, the red light will be on for 20 seconds and will be automatically closed
Specifications
- Device Type: Wireless Device
- Antenna: Internal
- RF Exposure Requirement: General RF exposure requirement in portable conditions
Troubleshooting
- Can not power on or shut: Put the earbuds back into the charger case and charge both.
- Can’t Pairing the earbuds with your device-Go to your smartphone’s Bluetooth menu and delete all saved devices from the list by clicking Forget this device*. Turn Bluetooth off then turn on on your smartphone. -Put the earbuds into the charger case 1 minute then take them out.-Retry to pair as the first time.
- Smartphone is connected to earbuds, but music can’t be sound
- Please check if the smartphone and earbuds are paired with each other.
- Please check if the Volume is shut off or too low.
- No sound on the left and right sides: after the successful connection between the headset and the mobile phone, there is sound while there is no sound.(Note: these two headphones are not paired successfully.) 1. Clear the pairing name on the mobile phone,2. Put the headphones back into the charging box, reset and take them out again. Wait until the two headphones flash green and enter the opposite ear Pairing status: after successful ear pairing, only one host will turn on the mobile phone when the green light flashes Search pairing connection.
Technical Parameters
Warranty Card
Please keep the warranty card properly
Packing list
FCC statement
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause u ndesired operation. Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, under Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used by the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and the receiver.
- Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
This device and its antenna(s) must not be co-located or operation in conjunction with any other antenna or transmitter.
Radiation Exposure Statement
The device has been evaluated to meet general RF exposure requirements in
portable exposure conditions without restriction.
FAQ
Q: Can I use the device near other antennas or transmitters?
A: No, the device and its antenna(s) should not be co-located or operated
in conjunction with any other antenna or transmitter to avoid interference.
Q: Is there a recommended distance to maintain from the device for safety?
A: While there are no specific distance requirements, it is advisable to
maintain a reasonable distance from the device, especially during prolonged
use, to minimize potential radiation exposure.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>