REVEL R-BT-6P EDEN Outdoor Barrel Sauna User Manual

May 15, 2024
REVEL

REVEL R-BT-6P EDEN Outdoor Barrel Sauna

REVEL-R-BT-6P-EDEN-Outdoor-Barrel-Sauna-PRODUCT

EDEN Outdoor Barrel

Due to our continued product improvement, the product illustrated in this instruction manual may vary slightly from the actual product.

RECOMMENDATIONS

Read this manual carefully before using your sauna for the first time. We recommend you keep it in a safe place for future reference.

  • Wood is a living element, to maintain its original appearance, it is important to treat the outside of the wood against moisture. Use a saturator only on the outside of the sauna.
  • Install the sauna on a perfectly flat and hard surface.
  • The sauna must remain in a dry area. Do not use it near a source of water (bath, damp floor, swimming pool).
  • Do not use liquid cleaning products. Disconnect the sauna before cleaning and use a wet rag .
  • Protect the sauna’s electrical cable to avoid it being crushed or pinched.
  • Before replacing certain components, ensure that they are specified by the manufacturer or that they have the same features as the original parts. Incorrect replacement can cause a fire, a short circuit or damage to the sauna. We strongly recommend using a qualified technician.
  • To avoid the risk of burns or electric shocks, do not use any metal tools.
  • Do not put animals in the sauna.
  • Do not leave the sauna switched on without supervision.
  • Do not leave the sauna switched on for more than 3 hours at a time to avoid premature deterioration of the equipment. After 3 hours of continuous usage, switch off the sauna for at least one hour.
  • We recommend that you do not install a locking system on the sauna door.
  • Check compliance of your electrical installation before connecting your sauna to the power supply.

SAFETY

IMPORTANT :
Please read the safety instructions carefully before installing and using your sauna cabin. They are essential for your safety, so please adhere strictly to them. Beware of hyperthermia, heat stroke or heat exhaustion which can be caused or aggravated by noncompliance with the safety instructions. Symptoms are fever, a rapid pulse, dizziness, fainting, lethargy and numbness in all or part of the body. The effects are: reduced awareness of the heat, ignorance of imminent risks, and loss of consciousness.

The sauna must not be used by:

  • Children under 6 years of age.
  • People with severe reactions to sunlight.
  • Elderly or disabled people.
  • People with previous medical conditions such as heart disease, high or low blood pressure, blood circulation problems or diabetes without prior medical advice.
  • Pregnant women. Excessive temperature can endanger the fetus.
  • Persons suffering from dehydration, open sores, eye disorders, burns, or sunstroke.
  • Children between 6 and 16 years of age may use the sauna provided that they are continuously supervised by a responsible adult and that the temperature does not exceed 60°C (140°F).
  • In the event of problems involving health, medication or injury to muscles or ligaments, do not use the sauna without previously consulting a doctor and obtaining approval.
  • If surgical implants are worn, do not use the sauna without previously consulting a doctor and obtaining his approval.
  • Do not use the sauna after strenuous activity.
  • Wait 30 minutes for your body to cool down.
  • Do not spend more than 40 minutes in the sauna at any one time.
  • Do not consume alcohol or drugs before or during the session.
  • Do not sleep in the sauna when it is in operation. To avoid the risk of overheating, connect your sauna to a sufficiently powerful electrical outlet and do not connect • other electrical equipment to the same wall socket.
  • To avoid any risk of electrocution or damage to the sauna, do not use it:
  • During thunderstorms.
  • If the electrical cable is damaged, it must be replaced by a qualified person.
  • If the electrical cable overheats, it must be checked by a qualified person.
  • If you have to change a bulb, wait until the sauna is switched off and cooled down.
  • Dry your hands before connecting or disconnecting the electricity.
  • Never work with wet hands or feet.
  • Do not switch the electricity or the heating system rapidly on or off as this could damage the electrical system. Do not try to repair the sauna by yourself without the agreement of the sauna’s distributor or manufacturer. Unauthorized attempts to repair it will invalidate the manufacturer’s warranty.
  • Do not use any type of detergent inside the sauna.
  • Do not pile up or store objects inside or on top of the sauna.
  • Do not place flammable materials or chemical agents near the sauna.REVEL-R-BT-6P-EDEN-Outdoor-Barrel-Sauna-FIG-1

EDEN OUTDOOR BARREL

REVEL-R-BT-6P-EDEN-Outdoor-Barrel-Sauna-FIG-2 REVEL-R-BT-6P-EDEN-Outdoor-Barrel-Sauna-FIG-3REVEL-R-BT-6P-EDEN-Outdoor-Barrel-Sauna-
FIG-4

Read the assembly instructions carefully before starting. Choice of location Designed solely for exterior installation.

Select a space:

  • In a dry area, on a flat stable surface that can support the weight of your sauna.
  • The height must be sufficient for you to reach the ceiling and carry out electrical connections and maintenance.
  • Away from any source of water, flames or flammable materials.

Practical advice

  • Note that sauna assembly requires 3 adults.
  • Clearly identify each panel before you begin
  • During assembly, position your sauna’s main cable so that it is easily accessible.
  • Note that there are variations between the models.

IMPORTANT: Please check the countersink and hole diameter of the drill holes to avoid damaging the wood.REVEL-R-BT-6P-EDEN-Outdoor-Barrel-Sauna-
FIG-6

ASSEMBLY INSTRUCTIONS

REVEL-R-BT-6P-EDEN-Outdoor-Barrel-Sauna-FIG-7

The front and rear panels need to be assembled as a whole first. The front panel is divided into three parts on the left and right, and the rear panel is divided into three parts on the top and bottom.REVEL-R-BT-6P-EDEN-Outdoor-
Barrel-Sauna-FIG-8

Each slat is numbered and labeled. The left side is L01 L02 L03…… L38 from bottom to top; The right side is R01 R02 R03…… R38 from bottom to top.REVEL-R-BT-6P-EDEN-Outdoor-Barrel-Sauna-FIG-9REVEL-R-BT-6P-EDEN-Outdoor-Barrel-Sauna-
FIG-10REVEL-R-BT-6P-EDEN-Outdoor-Barrel-Sauna-
FIG-11REVEL-R-BT-6P-EDEN-Outdoor-Barrel-Sauna-
FIG-12REVEL-R-BT-6P-EDEN-Outdoor-Barrel-Sauna-
FIG-13 REVEL-R-BT-6P-EDEN-Outdoor-Barrel-Sauna-
FIG-14

The sauna stove is a universal cable connected to an external customer power supply. The wires of the lamp should be connected to the wiring base of the sauna stove and powered through the sauna stove.REVEL-R-BT-6P-EDEN-Outdoor-
Barrel-Sauna-FIG-15REVEL-R-BT-6P-EDEN-Outdoor-
Barrel-Sauna-FIG-16REVEL-R-BT-6P-EDEN-Outdoor-
Barrel-Sauna-FIG-17

Turning the heater on immediately
Turn the timer knob clockwise to the “on” section (section A in figure 2, 0-4 hours). The heater starts heating until the timer returns to 0 and the lights turn on.

Presetting the time
To preset heating time, turn the timer knob clock- wise to the preset section (section B in figure 2, 0-8 hours). The heater will turn on, when the preset time has passed and the timer hasturnedtothe”on”-sec tion. The heater will stay on for approximately four hours. The lights are lit also during the preset time.

Example: You wish to bathe immediately after a 3-hour walk. Turn the timer knob to the preset section at 2. The timer in engaged and after two hours, the heater turns on. As it takes about one hour for the sauna room to be heated, the sauna is ready for bathing after three hours.

SAUNA MAINTENANCE

Protection of wood
Brush each exterior barrel slat and apply a wood stain when full assembly to protect the wood. This wood stain had to be renewed according to the recommendations of the product used Maintenance

IMPORTANT: Disconnect the cabin’s power supply cable before undertaking any work.

Problems identified Possible reasons Solutions

Electric stove does not heat up.

| The power supply cable was disconnected.| Check the power supply cable connection.
The general power supply is cut.| Check that the switchboard and wall plug are working
Stove is overheat protected.| Refer to the electric stove manual.
Sauna light fitting no longer work.| Light cable not fully plug.| Plug the cable.
Light is defective.| Contact your dealer.

Servicing :

  1. Disconnect your sauna.
  2. Use a vacuum cleaner to remove dust from crevices in the woodwork.
  3. Clean the cabin with a damp cotton cloth and use a small amount of soap if necessary. Rinse with a damp cloth.
  4. Clean the glass with a window/glass cleaner and a soft color.
  5. Maintain the exterior of the sauna every 2 years with a suitable product.

IMPORTANT

  • The wood should be treated with a protective product only on the outside of the sauna.
  • No treatment should be applied inside the sauna.
  • Do not use benzene, alcohol, chemical agents or strong detergents in the sauna since chemical products can damage the wood.
  • Do not spray water on your sauna.
  • Please read the instructions provided with the sauna stove for the installation and use of the stove.
  • The heater may only be connected to the electrical network per the current regulations by an authorized, professional electrician.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals