Mesqool CR1008R Digital Alarm Clock for Bedrooms User Manual
- May 15, 2024
- Mesqool
Table of Contents
Mesqool CR1008R Digital Alarm Clock for Bedrooms
LOCATION OF CONTROLS
- DST Indicator
- PM Indicator
- AM Indicator
- LOW DIMMER Indicator
- Alarm Indicator
- Battery Compartment Cover
- DST ON/OFF Slider
- Time Format Slider
- Set Time Button
- Alarm Volume Slider
- Alarm ON/OFF Slider
- Set Alarm Button
- Multi Color Button
- Type-C Output Charging Port
- USB Output Charging Port
- DC IN
- Speaker
- Hour Button/Light Dimmer Button
- Minute Button/Display Dimmer Button
- SNOOZE/LIGHT Button
PACKAGE LIST
POWERING ON
- Connect the power cord to DC IN jack , then plug into a 100~240V AC wall power outlet.
- Install 2pcs 1.5V “AAA” size batteries to the proper terminals in the battery compartment to memorize the time setting and the alarm will ring in case of power outage.
NOTE : Batteries (not included) don’t support time display or the night light function.
TIME SETTING
ALARM SETTING
- ARM Make sure the slide switch button ALARM ON OFF towards the left “ON”.
- Press SET ALARM button, the alarm indicator ALM will light up, the display starts flickering.
- Press HOUR button to set the hour, press MIN button to set the minute.
- Press SET ALARM button to save time, or wait for another 5 seconds to confirm automatically. ALARM VOLUME
- Slide switch button to adjust alarm volume.
Turn off Alarm
When alarm goes off:
-
Press SNOOZE LIGHT button to temporarily turn off alarm for 9 minutes.
Alarm will ring every next 9 minutes. -
Press HOUR or MIN, SET ALARM button to turn off alarm for 24 hours. The alarm indicator is still on, which means alarm is still activated and will ring after 24 hours.
-
To cancel alarm, slide switch button ALARM ON to OFF, alarm indicator ALM will disappear from the display.
NIGHT LIGHT
Turn on NIGHT LIGHT
-
Press SNOOZE LIGHT button then the night light will turn on.
-
Switch NIGHT LIGHT Color When the night light turns on, you can press SNOOZE LIGHT button to switch to the color as you desire.
The night light colors are as below:
-
Adjust Night Light Brightness
Press HOUR button to adjust the brightness of the night light to your preference -
Turn off NIGHT LIGHT
Long press SNOOZE LIGHT button for 2 seconds or press it repeatedly until the night light turns off.
RGB DISPLAY MODES
Press MULTI COLOR button to switch RGB display modes.
The digits will cycle through 10 available colors in the following order:
Random Color→RGB Left to Right Flowing→RGB Top Downward
Flowing→White→Red→Green→Blue→Ice Blue→Pink→RGB Changing
Notice When the digits are White, Red, Green, Blue, Ice Blue or Pink, you can set the display to LOW DIMMER modes with less light when sleeping.
OUTPUT CHARGING
Connect your phone or tablet charging cable with the Type-A or the Type-C
output charging port on the back of the alarm clock.
The alarm clock can charge both your phone and tablet at the same time.
The maximum charge current is 1Ampere.
WARRANTY
-
45-Day Full Refund
If you are unsatisfied with the product or you have any questions about the product, please contact us for a full refund or technical support. -
18-Month Warranty
If any quality problems occur within 18 months, please contact us for a replacement or partial refund. -
Life-Time Free User Support:
We offer free lifetime user support. Please don’t hesitate to contact us if you have any questions or concerns.