Mesqool CR2015 Emergency Alert Radio User Manual

June 9, 2024
Mesqool

CR1015
Emergency Alert Radio
with AM/FM/SW/NOAA weather

Chapter 1 LOCATION OF CONTROLS

Mesqool CR2015 Emergency Alert Radio - Controls

  1. Power Button
    Press Power Button to turn on radio, press it again to turn off radio.

  2. Volume Control Knob

  3. Telescopic Antenna
    To receive clear signal, you may plug telescopic antenna.

  4. Alert Flash Lamp

  5. WX/SOS Button

  6. Lock Switch
    The lock switch prevents accidental changing of any of the radio settings. Slide the lock switch to the up ‘locked’ position, the symbol will appear in the display. The power and all other buttons will be disabled.

  7. Battery Compartment

  8. LCD Display

  9. Timer/Clock Set Button

  10. Band Selection Button

  11. Tune- Button

  12. Tune+ Button

  13. Speaker

  14. Headphone Jack

  15. Belt Clip
    A removable belt clip is provided on the back of the unit.
    Removal:
    It can be removed by gently pushing on the center tab of the clip where indicated, and sliding the clip downward towards the bottom of the radio.
    Replacement:
    You can easily connect the belt clip by inserting the top of the clip into the designated receiver slots and gently pushing the clip in an upwards motion towards the top of the radio.
    Mesqool CR2015 Emergency Alert Radio - Controls 1

  16. Band Indicator

  17. Battery Life Indicator

  18. Timer Indicator

  19. Clock Indicator

  20. Alert Indicator

  21. Headphone Indicator

  22. Lock Switch Activated

  23. Frequence Indicator

Chapter 2 BATTERY INSTALLATION

  1. Turn radio off.
  2. Prepare replacement batteries to ensure a quick and easy change. Failure to change batteries within 1 minute will reset presets and clock settings.
  3. The battery cover is located on the back of the unit. Apply a gentle downward pressure and slide the door to the right side of the unit.
  4. Place 3 ‘AAA’ batteries inside the unit oriented to the illustration located just below the battery compartment.

NOTE: A flashing symbol appearing on the LCD display indicates a weak battery and that replacement of batteries is required. And the Weather lert will be deactivated.

Chapter 3 SETTING THE CLOCK

Press button to turn on radio, radio enter standby mode.
At the standby mode, press button to enter clock setting.
Press or button to adjust hours, press button to confirm.
Press or button to adjust minute, press button to confirm.
Note: Only in standby mode, then you can set the clock. If the radio stay in FM, AM, SW or WB mode, you can press button to enter standby mode.

Chapter 4 RADIO OPERATION

  1. Turn on radio
    Press button to turn on radio, radio enter standby mode, press butotn again to turn off radio.

  2. Band
    Repeatedly press BAND button to choose the band you want to listen to. You can choose from the AM/FM, Shortwave and Weather Band.
    To exit Band function, just press button.
    Weather Band: Receives all 7 weather band from NOAA, the U.S. National Weather Service which broadcasts in all 50 states, Puerto Rico and the U.S. Virgin Islands. 162.400 /152.425/162.45oti62.475/1€2.50/162.525/162.5SMHz
    AM Band: Receives all local AM stations from 520KHz to 1710 Khz.
    FM band: Receives all local FM stations from 87.50Mhz — 108.0MHz.
    SW Band: Receives all Shortwave bands from 2.3MHz- 23Mhz

  3. Volume Control
    Rotate VOL  Volume knob to adjust the sound volume.

  4. Manual Tuning Channel
    Repeatedly press or button to tune into the desired channel.
    Each press button, FM frequency will tune up by 0.1.
    Each press button, FM frequency will tune down by 0.1.

  5. Auto Scanning Radio Channel
    Hold press or   button for more than 2 seconds to start auto scanning.
    Scanning will stop automatically once it receive an available channel.

  6. Weather Band
    Repeatedly press BAND button to select WB band, then Repeatedly press or button to choose one of the WB band which is for your local weather station.

  7. Weather Alert Function
    Manual Setting Mode
    (1) To enable the NOAA Weather Alert function, press button.
    (2) When the function is enabled, the WX symbol on the LCD will flash.
    (3) When a weather alert is received, there will be an audible siren comes out, the flashlight, the symbol and the backlight on the LCD will flash.
    (4) After a weather alert is received, press any button, the audible siren will be stop, the flashlight and the backlight will be turn off, the symbol on the LCD will disappear. Radio will switch to 1-7 the weather channel which send weather alert automatically.

Standby Mode
In standy mode, Radio also can receive weather alert, when it receive weather alert, the radio will turn on automatically, and then it will sound an audible siren, the flashlight, the symbol and the backlight on the LCD will flash.

Chapter 5 SOS ALERT

In a emergency, you can turn on the flashing red SOS light and Alert sound.

  1. Hold press Button more than 3 seconds to turn on SOS alert.
  2. Press Button again, the SOS alert will be turned off.

Chapter 6 SETTING TIMER

When you listen AM, FM, SW or WB, you can set a timer, when the time is up, Radio will auto turn off.
Setting the radio channel which you desire.
Press button to active the timer, symbol will appear on the display, press or button to adjust duration 90min, 45min, 30min, 15min or OFF, press button to confirm your selection.

Chapter 7 SPECIFICATIONS

FM: 87.5 -108.0MHz
AM: 520-1710 Khz
SW: 2.3MHz- 23Mhz
WB: USA 1-7CH with Alert

Mesqool logo 1Contact our experts
service@mesqool.com
http://www.mesqool.com

Made in PRC
Version 1.0

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals