mesqool CR01001F Alarm Clock with Time Projection User Manual
- June 14, 2024
- Mesqool
Table of Contents
CR1001F
Alarm Clock with Time Projection
CREATE YOUR PERFECT SLEEP ENVIRONMENT
Chapter 1 LOCATION OF CONTROLS
1.SET TIME BUTTON
2.HOUR BUTTON
3.MINUTE BUTTON
4.DIMMER/DST BUTTON
5.SNOOZE/OK BUTTON
6.ALARM 1
7.ALARM 2
8.ALARM ON/PAUSE
9.PROJECTION ON/FLIP/OFF
10.VOLUME+ BUTTON
11.VOLUME- BUTTON
12.AM INDICATOR| 13.PM INDICATOR
14.ALARM 1 INDICATOR
15. ALARM 2 INDICATOR
16. DST INDICATOR
17. FOCUS RING
18. BATTERY COMPARTMENT
19. USB PORT
20. DC JACK
21.SPEAKER
22.HOLDER ( x 2pcs)
23. PROJECTION DIMMER
---|---
Chapter 2 POWERING ON
-
Install 2pcs 1.5V “AAA” size batteries to the proper terminals in the battery compartment to memorize the time/alarm setting in case of power outage.
Note: Without AC power in, batteries don’t support time display ,but alarm will still goes off. -
Connect the adapter line to DC jack , then plug into a 100~240V AC wall power outlet.
Chapter 3 TIME SETTING
- Press button once, display starts flashing.
- Press button to set the hour. press button to set the minute.
- Press button to save time or wait for another 10 seconds to confirm automatically.
- To change 12H/24H time format Hold press to change 12H/24H time format.
Chapter 4 ALARM SETTING
- Press button, the alarm indicator will light up, the display starts flickering.
- Press button to set the hour, press button to set the minute.
- Press button or button to save alarm time or just wait for another 10 seconds to confirm automatically.
- Press button to adjust alarm volume.
- Press button to save volume setting.
Turn off Alarm
When alarm goes off:
- Press button to temporarily turn off alarm for 9 minutes. Alarm will ring every next 9 minutes.
- Press button or button to turn off alarm for 24 hours. The alarm indicator is still on, which means alarm is still activated and will ring after 24 hours.
- When alarm is off, press button to active the alarm, setting will be the same as last time.
- Cancel Alarm
Hold press button until the alarm indicator will disappear from the display, the alarm will never goes off.
Chapter 5 PROJECTION MODE
-
Press projection mode button to turn on projection.
-
Press button once again to flip the projection reversely when the time projected backwards.
-
Press once again to turn off projection.
Note:
-
Best projection distance is 1.5 to 3.0 meters (4.92 to 9.84 feet).
-
Projector is a common LED light. So the projector is not visible in bright environment.
-
Rotate focus ring to adjust clarity of projection image.
Note: if projection is fuzzy,please rotate the focus ring (17) to adjust angle for clear image.
Chapter 6 PROJECTION DIMMER
Press button to adjust the brightness of projection for
your preference.
Chapter 7 DIMMER & DST
Repeat press button to adjust the brightness of display for your preference.
Hold press button to switch DST function.
Chapter 8 USB CHARGING
Our projection clock has a USB Charger Port, which can chargeboth your phone
or tablet at the same time.
The maximum charge current is 1 Ampere.
Contact our experts
support@mesqool.com
http://www.mesqool.com
Made in China
Version 3.0
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>