lbx C10 Vacuum Pump with PTFE Coating Instruction Manual
- March 20, 2024
- lbx
Table of Contents
lbx C10 Vacuum Pump with PTFE Coating
Please read the User Manual carefully before use, and follow all operating and safety instructions!
Important Notes
This instrument is designed for laboratory use only. Please read this manual carefully before installing or operating this equipment. The instrument shall not be modified in any way. Any modification will void the warranty and may result in potential hazard. We are not responsible for any injury or damage caused by any non-intended purposes and modifying the instrument without authorization.
- Check the voltage specified on the nameplate and ensure it matches the line voltage in your location.
- Install the instrument in a clean, dustless, and ventilated area under 40 ºC.
- Never use the pump with any flammable gas or toxic material.
- The pump is not designed to start against applied vacuum. To prevent damage, verify that the pump inlet is at atmospheric pressure before each start. If necessary, the inlet can be vented to atmosphere by partially unscrewing the vacuum regulator knob.
- When finishing pumping, please do not turn off the pump immediately. Instead, continue running the vacuum pump for at least two minutes to draw out any mist and tiny liquid, thereby prolonging the service life of the pump.
- This pump has a thermal protection device that automatically shuts off when it becomes overheated.
- The surface of the pump becomes very hot after use or during operation. Please avoid touching it to prevent burns.
- Do not use any lubricant, which may damage the pump.
- If the supply cord is damaged, please contact the manufacturer or your service agent for a replacement to prevent hazards.
- Warning: The PTFE-coated diaphragm and chamber offer good resistance to a wide range of chemicals, except for strong acids and alkalis.
Service
In order to guarantee this equipment works safely and efficiently, regular maintenance is required. In case of any faults, do not try to repair it yourself. If help is needed, you can always contact your supplier or Labbox via www.labbox.com.
Please provide the customer care representative with the following information:
- Serial number
- Description of the problem
- Your contact information
Assembly and Disassembly Diagram
| Position | Designation |
|---|---|
| 1 | On/Off Switch |
| 2 | Air Outlet |
| 3 | Air Inlet |
| 4 | Vacuum Gauge |
| 5 | Vacuum Regulator |
| 6 | Moisture Trap |
Operation
- Press the on/off (1) button to activate the pump after ensuring all tubing is securely connected.
- Set up the vacuum by adjusting the regulator (5).
- Warning:
When the pump is used for aqueous solution filtration, ensure that the liquid level in the flask does not exceed the safety level. Failure to comply could result in serious damage to the pump and void the warranty. If this occurs, please contact the distributor immediately for service.
Maintenance
- If the liquid level in the moisture trap exceeds 70 %, please stop the experiment immediately and empty the liquid.
- After completing the experiment, drain any liquid in the moisture trap and run the pump for at least 2 minutes to remove residual steam.
Warranty
This instrument is warranted to be free from defects in materials and workmanship under normal use and service, for a period of 12 months from the date of invoice. The warranty is extended only to the original purchaser. It shall not apply to any product or parts which have been damaged on account of improper installation, improper connections, misuse, accident, or abnormal conditions of operation.
For claim under the warranty please contact your supplier.
CUSTOMER SUPPORT
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>