Lordear SLF16014 Shower System Installation Guide
- May 15, 2024
- LORDEAR
Table of Contents
SLF16014 Shower System
Lordear
INSTALLATION MANUAL
FOR SHOWER SYSTEM
INSTALLATION
INSTRUCTIONS
Wall Mounted Installation
Lordear
Essential accessories list
Lordear
WARNING: Choking hazard. Keep all small parts and plastic
bags out of the reach of children.
Prepare the wall for installation.
(Note: The depth provided is for reference only. Please determine the
installation depth based on the actual thickness of tiles.)
Tips: Embedded box can be cut to flush with tiles before trim installation (Distance from back of valve body to finish surface to be between 2.6-3.4 inches)
Step 1: Install the Embedded box
Mark position
Step 2: Connect the water pipes with embedded box
Tips: Clean the water pipe to avoid any blockage, 1/2 inch male NPT
fitting connection to be made with pipe thread sealant, do not over tighten
Step 3: Remove the protective cover
Step 4: Install the handle to test the water
Tips: Test the outlet of Rain shower head
and handheld shower head.
Clean and maintain product
1.How to clean the shower head :
A. Rub the nozzles with fingers or toothbrush to loosen deposits, then run
hot water for a while .
B. Put the shower head in a pot, fill with enough white vinegar or Detergent
to cover the shower head. Then soak it for 30 minutes or longer.
C. Use a high quality microfiber cloth and gently wipe over the surface,
then rinse with warm water.Finally,use a dry chamois or paper towel to
gently remove any residue.
Warm Tips :
If you feel the flow is too small , you can take out the water
restrictor accordingly.
Guarantee Repairs Claims
-
During the warranty period, LORDEAR is responsible for free repairs of any
defective products and missing parts. -
Payment needed for replacement if the Malfunction and damage caused by
following situations even within the warranty period:
2.1 Improper use, unauthorized repair or reconstruction (including throwing
or beating);
2.2 Failure to follow installation manual (including unprofessional installation
by a plumber) ;
2.3 Removal after installation or other factors;
2.4 Usage beyond the specified scope. -
The recommended water temperature for the hand shower and rain shower
head is ≤42°C, with a water pressure of 0.1-0.3 Mpa. The highest suggested
temperature should not exceed 70°C, with a water pressure of 0.05-0.5 Mpa.
Therefore,it is advised to keep any product equipped with a shower away
from the heater to avoid potential risks.
THANK YOU FOR SHOPPING WITH US!
PLEASE DO NOT RETRUN TO STORE!
PLEASE CHECK ALL THE ACCESSORIES
BEFEOR INSTALLATION.
Tips: If there is any questions for the products, please
feel free to contact us. We will solve it at the first time.
For quick and better to solve problem for you,
Required information is a MUST：
1. Where you buy
2. PO Number/Tracking number
3. SKU Number
4. Problem to Clarify
5. Picture/Video
Email:lordear.guo@gmail.com
Tel: (+1)7053009828
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>