Shenzhen Carpo H368E Wireless Keyboard User Manual
- March 14, 2024
- Shenzhen Carpo
Table of Contents
Shenzhen Carpo H368E Wireless Keyboard
Instruction For Use
-
Insert the MINI receiver into the computer USB port as shown in the figure.
-
Firstly, check which system the computer is using, whether it is an Apple system or a WINDS system. If it is a MAC system, press FN+W so that the keyboard can be used on the MAC system. If it is a WINDS system, please press FN+Q so that the keyboard can be used on the WIDNS system. The FN+ENTER key can switch the color of the light, and the FN+SHIFT key can adjust the brightness of the light.
When the keyboard is not applicable, the lights will automatically turn off after 2 minutes. -
When the battery level is low. The light at the battery identification will flash, indicating that the battery is low and needs to be charged. The charging voltage is 5V. After fully charging, the charging indicator light will automatically turn off.
FCC Warning Statement
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment. This
equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>