Shenzhen Carpo Technology H288 2.4G Wireless Keyboard Instructions
- June 6, 2024
- Shenzhen Carpo Technology
Table of Contents
H2882.4G
- Plug the MINI receiver into the USB port of the computer (the MINI receiver is in the collection box at the bottom of the keyboard), as shown in the figure.
- Put 2 3A batteries into the collection box of the keyboard (pay attention to the positive and negative poles) and cover the collection box. Click any letter of the keyboard, and the keyboard and MINI receiver can be connected. After connecting, you can use your wireless keyboard. If you find that you can’t connect, you can pull out the MINI receiver, hold down the keyboard ESC+Q, the indicator light flashes red, and then insert the MINI receiver into the USB port of the computer. When the indicator light doesn’t flash, release the ESC+Q key, indicating that the keyboard and MINI receiver have been connected, so that you can use your wireless keyboard.
FCC Warning Statement
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>