Shenzhen Carpo 2ABKU-V890 Wireless Mouse User Manual
- May 15, 2024
- Shenzhen Carpo
Table of Contents
Shenzhen Carpo 2ABKU-V890 Wireless Mouse
Instruction For Use
-
Insert the MINI receiver into the USB port of the computer (the MINI receiver is located in the mouse’s bottom storage box), as shown in the figure
-
Turn on the power switch to the middle position, press any button of the mouse, and the mouse will automatically connect to the MINI receiver. If the connection is successful, the mouse can be used freely. Turn the power switch to the top, and the colorful lights at the rear will light up, causing the colorful breathing. When there is no mouse operation, the colorful lights will automatically turn off after 2 minutes. When the mouse power is low, the red light next to the scroll wheel will flash, indicating that the power is low. When charging the mouse (charging voltage 5V), the red light next to the scroll wheel will light up and the battery will be fully charged. The red light will automatically turn off.
FCC Warning Statement
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two MINI receiver conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>