TOMZON A34 Drone for Kids User Manual

TOMZON A34 Drone for Kids

Fly safe

• Avoid leaping or getting near to the crowds, trees, high voltage power lines, buildings, airports or territorial waters, as well as high-intensity power line base stations.
• Do not use the product under bad weather conditions, such as rain, snow, fog or when the wind speed exceeds 5m/s or 10mph.

Accessories List

Drone Overview

Drone Light Status

Remote Control Diagram

1. Slow/ Normal / Fast
   (Short press to switch the flying speed)

2. Left control stick

3. Trimming

4. Power button

5. Right control stick

6. Intelligent Flight Mode
   (Short press to start I Pause rotation mode, long press for 1 second to start/ Pause surround mode)

7. Lighting switch
   (The drone is available in 5 light modes, which can be controlled by the light switch button. Short press to switch between the 5 light modes in turn, long press to turn off the lights.)

8. Take off / Land
   (Short press to take off/ Land, Long press for 3 seconds to trigger emergency stop)

9. Headless mode

10. 3D Roll

Prompt:

1. The drone supports two control modes, mode 1 and mode 2.
Mode1: The Left joystick controls the drone’s ascending/ descending, turn left/ right; The Right joystick
controls forward/ backward, left/ right side flight.
Mode2: The left joystick controls forward I backward, turn left/ right; The Right joystick controls drone’s ascending/ descending, left/ right side flight.
Mode 1 is the default setting when the remote control was turned on.
To switch the mode 2: Press and hold the key 1 and then turn on the remote control.
2. The following describes the control methods, taking mode 1 as an example.

Operation Method

| Ascend/ Descend / Left / Right Turn| Use “left control stick” to control the altitude & rotation during flight.|
---|---|---|---
2| Forward/ Backward / Left / Right| Use “right control stick” to control forward / backward / left / right during flight.| | |
---|---|---|---|---|---
| | |

| |
| |
| |
| |
3| Fine-adjusting to the left/ right/ forward/ reverse side| When flying , if the drone moves to the right, adjust it by fine tuning on the left. When the drone moves to the left , adjust it by fine tuning on the right. When flying , if the drone is offset backward , it shall be adjusted by fine tuning according to the front; when the drone is offset forward, it shall be adjusted by fine tuning according to the rear.
| |
| |
| |
| |
| |
| | |

| |
| |
| |
4| 360° rotationto the left/ right/ forward I reverse| Short press the upper right button, then push the right joystick to the left/right/up/down, and the drone will roll 360° to the left/right/up/down
accordingly.
| |

5

| Throw to go| The drone can take off automatically after being thrown manually. Please connect the drone to the remote control and calibrate it, then hold the drone in your hand and toss it into the air. As shown in picture below.|

Headless Mode

The drone flies at a fixed direction and does not change with the direction of the drone, as shown in picture below:

Tips:
The default is head-on mode, please press ” (headless mode button) to switch to headless mode.

Install the remote control battery

Use the screwdriver to press down to the position shown in the figure, and open the battery cover to install the battery (not included).

Charging the Aircraft’s Battery
Press the battery clip and pull the battery out then the battery can be taken out from the aircraft.

Lithium battery charging instructions

1. Taking out the USB charging cable, connecting the battery port to the charging head, then plug the USB terminal into the USB port on the computer (or USB power adapter) to charge the battery. The USB charger light stays red when charging, and the light stays green when charging is completed.
2. Aircraft’s lithium battery charging period is 120 minutes(depends on the charging power source ).

Notices for charging

• Please use the original cable to charge the battery. Do not use generic cords.
• Do not place the charged battery in a place of high temperature and healing, such as a flame or an electric healing device, otherwise damage or explosion will occur.
• Do not strike or hit a hard surface with a battery.
• Do not disassemble the battery.
• Do not put the battery in water, the battery should be stored in a desiccative place.
• Personnel must not leave when charging.

Malfunction Slaving Guideline

the drone
The remote controller’s battery is low and the power indicator will flash.| Change the remote controller’s battery.
The frequencies of remote controller and the drone are not matched.| Re-match the frequencies of the remote controller and the drone.
Response of control is not sensitive during flight| The remote controller’s battery is low or poor battery quality.| Replace the battery with better quality.
There are remote controllers with the same frequency is transmitting interference.| Change to a place that does not have devices with the same frequency to transmit interference.
Deflecting while hovering| No horizontal calibration.| Do horizontal calibration again.

Specification

included)
Working environment temperature: 0 ~ 40°C|
Working frequency: 2.402 ~ 2.483GHz
Battery| Charging Cable
Capacity: 650mAh 2.4wh| Rated input: DC 5V/1A~2A
Voltage: 3.7V| Rated output: DC 4.42V=800mA
Battery type: Li Po 1S| Rated power: 3.54wh
Working environment temperature: 0 ~ 40°C|

FCC

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help

Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference that may cause undesired operation.

Shiyan Street, Baoan District, Shenzhen
Battery information| Capacity: 650mAh, 3.7V 2.4wh
Adapter information| Input: 5V = 1A~2A
Output: 4.42V = 800mA
FCCID| 2AYUO-A21
EC REP: E – Cro ssS tu GmbH . Mainzer Landstr.69,60329 Frankfurt am Main -=©-

UK REP : DST Co. , Ltd . Fifth Floor 3 GowerStreet, London, WC1E 6HA, UK

www.tomzontoys.com ****support@tomzontoys.com

& CAUTION

This toy is recommended for children 14 years of age and older. To ensure that the child’s play is both safe and fun, please read the operating instruction and the general safety rules with your child.

• Keep eyes, face, fingers and hair away from the rotor blade, tail blade and gear, as they will rotate at very high speed while the aircraft is flying.
• Adult supervision is recommended when the aircraft is being operated.

& WARNING                               (A\ DANGER

Warning: The product should only be used by adults and children over 14 years. Adult supervision is required for children under 14 years.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>