Tomzon A23-W Mini Drone Camera User Manual

June 15, 2024
TOMZON

Tomzon A23-W Mini Drone Camera User Manual
Tomzon A23-W Mini Drone Camera

Pack List

  • Drone

  • Remote Control

  • User Manual

  • Propeller (A / B)

  • USB Charging Cable

  • Battery

  • Mobile Phone Holder

Safety Reminder

  1. It is forbidden to use all types of drones within a radius of 5,000m and center point area of airfield runway, in order to guarantee the electromagnetic environment requirements of the aviation radio. No remote control and drone shall be used when radio control instructions are issued by relevant state authorities.
  2. Please use the drone indoors, or in a warm, sunny and windless weather outdoors. It is forbidden to use it in high temperature, low temperature, strong wind, thunderstorm and other bad weather conditions.
  3. Please keep a safety distance from people, pets, wires and other obstacles when using the drone indoors or outdoors, and keep the drone within your line of sight to avoid accidents.
  4. Once the drone is started, do not touch the parts such as high-speed gears and propellers to avoid injury

Product Description

Drone
Product Description
Product Description

Tips:

The aircraft has two types of propellers (“A” and “B”) marked A and B.
Please match the Mark “A” or “B” while replacing the propeller.

Remote Control

Remote Control

Remote Control

Tips:

The drone supports two control modes: Mode 1 and 2.

Mode 1: Use the left joystick to make the drone fly up / down, rotate left / right; use the right joystick to make the drone up / down / left / right.

Mode 2: Use the left joystick to rotate to the front / rear / left / right; use the right joystick to make the drone fly up / down / left / right.

Note:

Mode 1 is the default setting. Please press “Set speed” button and turn on the remote control to switch to Mode 2. Take Mode 1 for example to introduce the control method of the drone.

Mobile Phone Holder Installation

Insert the mobile phone holder into the upper holder slot of the remote control as shown in the picture.
Holder Installation

Battery Installation of Remote control

Open the battery cover of remote control and install 3 AAA batteries (not included in the packaging) as shown in picture below:
Battery Installation

Tips:

  1. Be sure that the batteries of the drone and remote control are fully charged before flying. Otherwise, the drone cannot take off in low battery mode.
  2. It is not recommended to have mixed use of acid and alkaline batteries. Please take out the batteries when drone is long id

Battery

Battery Installation and Charging

  1. Place the battery in the drone and buckle it as shown in picture below:
    Battery Installation

  2. Recharge the battery as shown in picture below: USB charger indicator turns red during charging. Once charging is done, the charger indicator turns off.
    Battery Installation

Note:

  1. Please use the original charger for charging. Do not use other chargers.
  2. Keep the battery away from high temperature, open fire or electric heater; otherwise, damage or explosion may occur.
  3. If the product is long idled, please charge it bi-monthly to keep the battery in active condition.
  4. Do not charge the battery on carpets, and other flammable items to avoid fire.

App

Download FLYCAM

For smartphones with Android 5.0+. Search and download “FLYCAM” on Google Play, or scan the QR code below.

For smartphones with iOS 9.0+.Search and download “FLYCAM” on the App Store, or scan the QR code below.
QR Code

FLYCAM APP

Connect to your phone

A23W can be controlled directly from your smartphone as follows:

  1. Turn on the drone, then go to “WiFi Setting” on your mobile phone and connect to “Tomzon_A23W_xxxxxx”.
  2. Open “FLYCAM” APP and enter the operation interface.
    App Connect to your phone
    A23W can be controlled directly from your smartphone as follows:
    Please notice that if the drone is connected to both your phone and the remote control, the flight of the drone in this case can only be operated by the remote control;
    if you prefer to control the drone with your phone only, you should turn off the remote control first. The control distance of smartphones is up to 30 meters (98 feet) in an interference-free environment

Operation Interface

Operation Interface 

  1. Home
  2. Drone Status
  3. Signal
  4. Battery Capacity
  5. Setting
  6. Photo / Video
  7. Take Photo /
  8. Camera Setting
  9. Photo Gallery
  10. Intelligent Flight Mode Settings
  11. One-button Takeoff / Landing

Intelligent Flight Mode

Intelligent Flight Mode

  1. Speed Adjustment
  2. Head-on Mode
  3. Horizontal Calibration
  4. Virtual Joystick
  5. Gravity-sensing Mode
  6. Trajectory Flight

A23W drone has two remote control modes, mode 1 and mode 2. Mode 1 is set by default.
control modes

Quick Start

Frequency Match

  1. Long press the power button on upper cover to turn on the drone and indicator flashes; then place the drone on a horizontal ground.

  2.  Turn on the remote control and it pairs the drone automatically. The pairing is complete when the remote control beeps. At this time, the Indicator lights of the remote control and the drone are always on.

Calibration

Press “ ” (calibrate button) to start calibration. The indicator light flashes rapidly during calibration and after the calibration is completed, the indicator light is always on.

When drone falls, please calibrate it again (place the drone on horizontal ground during calibration).
Frequency Match

Takeoff and Landing

Method 1

As shown in picture below, press “ ” (one button takeoff / landing) to take off (when drone takes off, press this button to land).
Takeoff and Landing

Method 2

As shown in picture below, push both joysticks simultaneously to unlock the drone, then push the left one upwards to take off (after the drone takes off, push the right one downwards to land).
Takeoff and Landing

Emergency Stop

In case of emergency, press and hold the “STOP” button for 1 second, the drone stops working and falls.

Tips:

The motor should only be stopped in case of emergency to reduce the risk of damage.

Flight

Note: Take remote control Mode 1 for example

High Speed and Rotation

Use the “left joystick” to control the height and rotation of the drone during flight.
High Speed and Rotation

Front / Rear, Left / Right

Use “right joystick” to control the left / right direction during flight.

“right joystick

Headless Mode

The drone flies at a fixed direction and does not change with the direction of the drone, as shown in picture below:
Headless Mode

Tips:

The default is head-on mode, please press “ ” (headless mode button) to switch to headless mode.

Fine-tuning

If the drone is tilted to certain direction, instead of a stable state, press the fine-tuning button after takeoff to the opposite flight direction to reach the stable state.
Fine-tuning

Aerobatic Flight

3D Rotation

Step 1: Press “ ” (rotate button) to enter the rotation mode and the remote control beeps continuously.
direction

Step 2: Push the right joystick upwards and the drone immediately rotates forward 360°.
direction

Tips:

To make the drone rotate in the other direction, push the right joystick to the other direction in Step 2.

Rotation Mode

As shown in picture below, shot press “ ” (rotation button) to enable / disable the rotation mode, and the remote control makes a “beep” sound. In this mode, the drone rotates at a fixed speed.
Rotation Mode

Orbit Flight Mode

As shown in picture below, long press 1s “ ” (orbit flight button) to enable / disable the orbit flight mode, and the remote control makes a “beep” sound. In this mode, the drone flies along a circular orbit.
Orbit Flight Mode

Tips:

  1. In this mode, only the up / down process of drone can be controlled.
  2. The drone exits this mode automatically when you push the right joystick.

Throw Mode

The drone can take off automatically after being thrown manually.

Please connect the drone to the remote control and calibrate it, then hold the drone in your hand and toss it into the air. As shown in picture below:

Safety

Low Battery Alarm

When voltage is lower than 3.5V, the indicator of the drone flashes slowly in red and the remote control beeps, and the drone lands automatically when the battery runs out. Be careful of the battery power during the flight.

Low Signal Alarm

When the drone loses connection with the remote control, it lands automatically and the remote control beeps. Please make sure the drone is in your line of sight.

Drone

Drone

Takeoff Weight| 34g
Working Frequency| 2.4G
Max. Distance of Remote Control| 30M
Battery| 3.85V 380mAh
Working Temperature| 0-40°

Remote Control

Working Frequency: 2.4G
Battery of Remote Control: 3*AAA batteries

FCC

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

  • Reorient or relocate the receiving antenna.
  • Increase the separation between the equipment and receiver.
  • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
  • Consult the dealer or an experienced radio/TV technician for help.

Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

(1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

Name A23-W
Model A23
Manufacturer Shenzhen Deepsea Excellence Technology Co., Ltd.
Address 5th Floor, Building 7, Hongfa High-tech Park, Keji 4th Road, Shiyan

Street, Baoan District, Shenzhen
Battery Information| 3.85V 380mAh
Charging voltage/current| 5V 1A
FCC ID| 2AYUO-A21

EC REP: E-CrossStu GmbH. Mainzer Landstr.69,60329 Frankfurt am Main
UK REP: DST Co., Ltd. Fifth Floor 3 Gower Street, London, WC1E 6HA, UK

CAUTION

This toy is recommended for children 14 years of age and older. To ensure that the child’s play is both safe and fun, please read the operating instruction and the general safety rules with your child.

  • Keep eyes, face, fingers and hair away from the rotor blade, tail blade and gear, as they will rotate at very high speed while the aircraft is flying.
  • Adult supervision is recommended when the aircraft is being operated.

WARNING

Warning: The product should only be used by adults and children over 14 years.

Company logo

References

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals