ITT SLR TILE02 Adjustable Hook Roof Mounting System Instruction Manual
- May 15, 2024
- ITT
Table of Contents
ITT SLR TILE02 Adjustable Hook Roof Mounting System Instruction Manual
Use
Mounting system for installing framed PV modules with heights between 30 and
50mm on pitched roofs with
the following characteristics:
- Roof pitch s• – 60° (solar fasteners}, 20°- 600 (Roof hooks)
- Single and double roman, plain tile, natural slate, and flat tiles with wooden substructures.
- PV-panel landscape and portrait oriented
Static calculation must exist and be considered according to local regulations.
Installation guidelines
Ensure that the roof construction is suitable for the introduction of forces at the fixing points and their subsequent transmission. In order to compensate thermal expansion, included a break every 12 meters when planning the PV- system. For module positioning/fastening points please refer to manufacturers recommendations. Please follow your local timber construction standard. Please do not use installed roof connections as ladder. If installation is located within 10km from the coast, we advice not to use zinc coated material. For further information please contact your sales representative or the technical department at ITT Bulgaria EOOD.
The structural stability of the PV system must be verified before installation. The building must be able to support the additional weight safely.
Installation notes
Please read these installation instructions carefully before starting the
installation and familiarize yourself with the system components. During the
installation and in particular whilst working on the roof, ensure to work
according to the relevant health and safety guidelines, safety guidelines and
please follow the current rules and regulations for your corresponding region.
The individual installation instructions are merely recommendations in
accordance with the current state of technology and are based on previous
experiences of how Hopergy systems can be installed. If any special
characteristics of the roof or object need to be taken into account, we
recommend you to consult specialists such as roofers or structural engineers
where necessary. Please check that the applied manual which is up to date. All
manuals are available in the download area at https://itt-shop.bg/
Testing/ certification:
- TUV
- MCS012 (IK0197}
- ISO 9001
Applicable Documents
- General installation, maintenance and assembly instructions”
- Safety Instructions for Installation Instructions”
These documents are available at https://itt-shop.bg/
ITT Bulgaria EOOD is not accountable for the roofs capability to maintain the introduced forces. Please check the roofs compatibility with a static engineer.
TIN ROOF MOUNTING System
SOLAR PANELS LAYOUT
Installation Steps
Step.1 Remove or slide the tile from the roof girder slightly, and place the roof hook on the wooden rafter (refer to the picture below), Fix the roof hooks using three wooden screws. Grind tile as required and replace. (Recommended Torque:9-llN.M)
INSTALLING RAIL
Step. 1 installing SSC rail.
Installing the rail
Step. 1 There are type for the SSC rail. ( Select Rail Joiner)
Step. 2 Repeat the tile roof hook installation in accordance with the planned layout.
Install Select panel clamps.
① . Against the panel, Hold it with your thumb
② . Against the panel, Hold it with your thumb
Attention：1.The panel clampis close against the solar panel.
2.Tighten the bolt slowly, until the clamp in holding position.
3.Then use 12-14N.M torque to tighten the bolt.
*Ensure The Lock Nuts Are Secured to Rail.
◎Solar panel installation completed. Double check ensure all bolts be tighten
COMPONENTS
Documents / Resources
| ITT
SLR TILE02 Adjustable Hook Roof Mounting
System
[pdf] Instruction Manual
SLR TILE02 Adjustable Hook Roof Mounting System, SLR TILE02, Adjustable Hook
Roof Mounting System, Roof Mounting System, Mounting System, System
---|---
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>